Network Security

Dear team,I have Checkpoint firewall for my DC and i am planning to deploy Cisco Firepower 2130 ASA for my DR .I would to replicate the same configuration on Checkpoint firewall to the Cisco ASA firewall.what tool can convert this best and what do i ...

the failover is working,

Hi everyone,I'm wrapping up an assignment for my networking class. For the assignment I have to build a VPN tunnel between two ASA 5505s. I've managed to do this, but have a very strange problem. Every time I close and reopen my topology in packet tr...

Hi all!  Hoping one of you can shed some light before I tear out what remains of my hair (not much, but I value it!) Have a Cisco ASA running 9.2.  From factory reset did a quick configuration to test since I'm used to the old school PIX units and kn...

 Hi ,I don't have a physical switch for dmz .Now If I want to  share the same  inside network switch ,what is the solution Thanks    

In Firepower managed by FTD ,  the secondary fails a policy push

Hello , in our clients monitoring tool we see these message , Interface Internal-Data0/0(): High error rate...... The devices are FTD's 1150 in HA mode . I understand that this interface is internal to the device and move traffic into and out of CPU ...

I'm upgrading an old (OLD) Cisco PIX to a newer ASA unit.  Of course when I migrated the config (via CLI), it didn't like some of the old NAT commands and I had to modify appropriately.  I have 2 interfaces configured (inside 100 and outside 0).  I h...

Hello All, 5 years back we had purchased two attendant consoles licenses for two of our desktops. now we are replacing one of the desktops and would like to transfer 1 license from old desktop to the new one. unfortunately the ID we used during the p...

Hello All, We have a traditional Cisco Account under which we have purchased different licenses(switches, firewall, AP, PI, etc) for our end-user. now we want to transfer all these licenses to our end-user's smart account. can anyone help me with how...

I have figured out the the router ip address are currently in the down position and need to be turned on. I can not figure out what else I need to configure so the the pings are working the way they are suppose too. I could use any hints. It is all w...

We have an HA pair of 4110 FTDs that was running 6.6.4 until around 1.5 weeks ago when we upgraded to 7.0.1. Since then, we've had several reports about poor performance, with many stating latency problems. The connection event table is showing the t...

I've been able to find out information about the new features of FDM ver 6.7 on the Cisco pages, the same for the case of FMC. This applied to a FP1010 appliance. However, I'd like to know the complete features that FDM ver 6.7 supports and compare i...