Network Security

Hi,using C6K5 in hybrid-mode. QOS-features for theATM-Interfaces which is seated in a FlexWAN-Modulehas to be done on the MSFC.I created a map-class which matches all ipx-traffic.class-map match-any IPX-CLASS description QoS Class for IPX-Traffic mat...

I have a PIX515E with a Linux based sendmail Server sitting in inside LAN. Server has a private IP in the range of 192.9.200.x. I want this to be accessed globally with a public IP of 203.122.23.149. Kindly let me know the what static command in need...

Hello All, i would like to asks someone what to do with logging on fwsm. 1) logging messages has no information about interface. at PIX logs you can find interface name:ip address where the connection starts and ends. but at fwsm logs there is only i...

Traffic flows (inside hosts going out) using PAT stop for random amount of time. When clear xlate command is issued on the pix, it enables the flows right away. Have tried different timeout values for conn,xlate etc but the problem still exists. Curr...

Hi,I have 3 interfaces, outside, inside and DMZ. The DMZ servers are NAT'd to Public IP. I am allowing PUblic to access the DMZ servers via Public IP. eg:static (dmz, outside) 161.10.10.10 172.16.2.10 netmask 255.255.255.255staic (dmz, outside) 161.1...

Any ideas?A customer of mine has IPX running over private lines to customer sites and we wanted to set up a PIX on our end to have some sort of security in place. We enabled GRE on the outside interface and could pass traffic although very slow. So w...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

I am new to Cisco PIX. We have a PIX 501 and I am not able to access the Device manager through the browser. I get a screen where it says the device manager is loading, but it doesnt go anywhere. BTW I am trying to access from a Windows 2003 Server. ...

Hi I have 2 networks: 10.120.1.0 and 10.125.1.0. This basically is connected on the 2 interfaces of Router i.e 10.120.1.0 to fa0/0 and 10.125.1.0 on fa0/1. The firewall 10.120.1.60 is connected on 10.120.1.0 and i am able to access internet from this...

One of our customer has pix 501 with 10 license, in sh ver command inside host is 10 and throughput is limited. They had only 5 users, now they have increased to 20 users.Randomly some times, for some users internet does not work and then starts work...

When I attempt to install Management Center for Cisco Security Agents 4.0 as part of the Cisco Works VMS 2.2 upgrade, the installation fails with the following error:"Configuring ssl mode for cmf apache... failed. Aborting installation."The server is...

I am trying to set up a PIX501 so that an outside W2K mobile user can IPSEC/L2TP into the "inside". I'm using PSK.It works perfectly without a NAT box in between, but when I have to cross NAT (using NAT-T), phase 2 negotiation fails. I have enabled N...

Hi,Have a bunch of sites connecting using 501's.(IPSEC)Two sites upgraded their dsl line and when trying to configure the VPN tunnel at each site to point to 6 other sites I was able to get 4 tunnels up with a lot of difficulties and I even had to bo...

Hi,I have two PIX with UR licence. Will I be able to use one as failover if I connect the ethernet interfaces back to back ? Thanking you in anticipation.Regards,Bipin