Network Security

Is there any automated file maintenance available for the log files created by the DFM FileNotifier. I'd like to leave this on for archive purposes? But I don't see anywhere to have this file rewritten at specific intervals.Thanks

hi i need a very basic info of placing a PIX in a small N/W.we hve a LL from ISP terminating in our router and we hve a small group of pcs(in private subnet).right now i hve connected my routers eth,pix public eth in a seperate switch.private eth por...

what are the commands to configure catalyst 2950 to work with ciscoworksthanks & regardsshoeb

Could anyone tell me all MIB's I need to manage a Catalyst 6500/Cisco 7600? Or better, do you know any documents where I could find this information?Thanks for your help.

Does PIX understand 802.1P ?

I have question about the behavior of PIX at 6.3.1. TAC's response is: it's in early deployment, insinuating that it is not fully supported, go back to last release. Looking at the software page, you have to go all the way back to 6.1 code train to g...

I have a PIX515 UR and have problems with it trying to failover. It is not in a failover configuration and has no failover cable attached. It's been fine and started acting up after applieing the 3DES/AES license. The config has "no failover". The PI...

Hi folks!, quick question........... i have a PIX 520 to play with. I was wondering, if it's possible to do failover with a lower model like a 515?many thanks

When selecting "Shun Connection" on the sensor, v4.1, the pix blocks the entire host...regardless of what ports or protocols are used. Anyone see this?Pix V6.3(1). The pix config shows the shun line the same for both shun host and shun connection. Bo...

Como puedo ver la utilización del Ancho de Banda de un enlace Frame-Relay con CiscoWorks 2000

I purchased the PIX 501 for my home broadband connection. Prior to installing it, I am trying to learn it at work.I can't get ethernet0 to accept a DHCP assigned ip. Probably something simple.Should I be using a crossover or straight through cable ?

Hi Nadeem: my question : in the pix dmz interface ,It have two hosts,using the ip address:172.10.10.35 for service,but the ip is virtual ,the real hosts ip are 172.10.10.33,172.10.10.34;clients access the 172.10.10.35 ,and the active host(example 172...

All -->Here's the scenario, I just picked up a PIX 501 for my home use. I have an SBC DSL package, and the SBC client establishes connectivity using PPPoE. Does anyone else have any experience setting this up? I can't get the communication to establi...