Network Security

I want to have timestamps on my Pix's syslog messages. I have ntp running ok, and I have configured the commands below. logging timestampslogging onlogging host inside (ip address)Alhgough I still have no timestamps in the syslog messages. Any ide...

Is it possible to have lan to lan tunnel b/w pixes with a router doing natting between them. Also what if one one vpn endpoint was a router is it possible. Scenario,One end pix gets a dynamic ip add from DSL router and all traffic through the DSL rou...

Can the PIX (Ver6.2) be used as a PPTP client to connect to a MS server and thereby sharing the VPN connection using 1 IP address? I currently have MS Clients passing through the PIX to a MS server and all is working well until I run out of IP addres...

Gents,I mean once inside private IP addresses are translated to global address.cud anyone ping those ip address (global one)from Internet.I have enabled conduit permit icmp any any (Is this the reason or PIX sud have done this by default)2- why and a...

i looked through the various topics for something similar and didn't find anything. if this is already posted, please accept my apologies.anyway, i have a pix515e, running ver 6.1(2). it has 6 interfaces, internal, external, and 4 DMZs (intf1, intf2...

I set up a gre tunnel from a router outside the firewall to one behind the firewall. When I ping from one side to the other the pings go through for a little bit then stop for a couple seconds, then start again. I can give more info if anybody wants ...

Hi,Is there a way to download Configuration from a PIX 515E using either TFTP or FTP ? As you can do it on Routers by defining the "tftp-server nvram:startup-config ..." command.Regards \\ Naman

is there a way to configure some sort of extended service check (i.e. send string to look for particular web page) on the CSS switch to member servers on a specific pool?

Hi all.Reading the docs, when 2 pix are in LAN FAILOVER situation (without stateful link), primary unit is active and secondary unit is standby.When primary goes down, secondary get the active status and start toaccept traffic.When primary goes up af...

I've inherited a situation....Class B IP range subnetted to all Class C networks. PIX to be inserted behind the router to public internet , outside interface connected to the router via crossover cable with one Class C network assigned to that link...

Our setup is as follows:traffic comes into and out of the office through a 2610 The 2610 is connect to a PIX 515E. It controls the layer 3 WAN tunnels to our units.What we would like to accomplish is to connect to one of our vendors via a 515 to 51...

I have a PIX with 2 interfaces: "inside" and "outside". I have no problem when a packet coming from a "inside net" PC (C) has to go outside. But if I have to reach an other network that is "inside" (192.168.0.0), it doesn't work; let's see the sch...

Users of our VPN using WIN 98 get a Windows login to log into thje internal network. With Windows XO home, the option of the Windows login does not appear. Users can connect to the VPN, are granted a VPN IP address,. The DNS and DHCP servers are a...