Network Security

Can you telnet "from" a PIX?

What do you have to add on the PIX so that clients can access the outside (internet) when the clients are only setup for IPSec so that clients on the Outside interface can access them using the VPN client? Does anyone have any ideas - ?

2002-05-12 18:03:44 Local4.Critical 192.168.1.1 %PIX-2-106017: Deny IP due to Land Attack from 10.1.1.10 to 10.1.1.10What might be causing this?

Does PIX 6.21ED code support NAT Traversal?????

I have this remote site behind a Netgear NAT router connecting to a PIX 501 here through PPTP. The PPTP tunnel is established correctly but the users from that site receive no response when they ping my internal IP addresses.The remote site subnet is...

Hello Everyone,I am having touble with configuring PPTP to work with the PIX 501. I have 5 global static addresses and am using one for pat for the internal network and one for pptp traffic.I have created a static map for the PPTP on the pixstatic (i...

Help. Looking for a sample config or the commands to configure PPPOE on the new PIX code.Specifically How do I send a Username and Password from the PIX to a Terminating Device (ISP Equipment).Thanks, Tom P

I set up the ssh on on PIX 501 , made the rsa key 1024 and all that - domain name etc.. and did the ssh cmd:ssh x.x.x.x 255.255.255.255 outsideMy question is what Username do you USE..? Can I make one in PIX? I have tried "pix", "cisco" and my domain...

Ok I have been through every thread on this forum and have found this same question posed several times but no answers seem to work for what I have currently and I never saw anyone say "Hey that worked" so I am posting it again......I know how to do ...

We have 535 pair in failover mode. We had 2 interfaces in Gibabit port (Inside and NOC) and the rest in Fastethernet (outside, DMZ and failover). We were facing a problem with PIX failing over without any interfaces failing and the Gigabit interfaces...

I just bought a PIX 520 and need to find out if it's the failover, restricted, or unrestricted bundle. Here is the show version from it:pixfirewall# sh verCisco Secure PIX Firewall Version 5.2(5)Compiled on Mon 05-Feb-01 20:01 by morleepixfirewall up...

Does the new Pix Firewall Software 6.2.1 support RSA Security Dynamics (SecurID Ready) Authentication and Accounting Server, so I can use the aditional RSA SecurID Features like the New PIN Mode ??

I have 4 remote Routers (2610 with 12.2 software) and a central PIX 515 (PIX6.1 software) and I want to create VPN tunnels in a HUB-and-SPOKE topology (all the VPNs terminated to the central PIX). When I configure only one VPN on the PIX (for one of ...

Ok I have been through every thread on this forum and have found this same question posed several times but no answers seem to work for what I have currently and I never saw anyone say "Hey that worked" so I am posting it again......I know how to do ...

If I have 4 interfaces on my PIX535 is it possible to use two interfaces as inside and two as outside, ex. "inside", "inside2", "outside", "outside2" and then let the inside interfaces use nat for the same address space and let the the outside interf...