Network Security

I have a public ip address, and have a sprint dsl. When the dsl was first installed the rep set the sprint router up with one of my public ip addresses so the workstations could access the internet. That works fine. Now i am trying to install a pix 5...

Some Pix 501 with PPPoE (dhcp) are connected to PIX 515 central office on Outside interface.Some Pix 506E would connect to PIX 515 central office on dmz interface and would communicate with PIX 501 throught the PIX 515.Do I need static IP for PIX 506...

I have a Pix 515 ver 6.2 that I'm trying to create a static map between my inside and DMZ interface. I have a host in the dmz that needs to access a database on the inside. I've tried setting it up several different ways, but when I following the man...

Dear AllIt is my first time to use this connection, so i hope to find helpful guys.Actually i need to how to perform or either if these points are supported or not.1. Mail Guard: removes need for external mail relay server in perimeter network2. DNS ...

Will PIX support VLAN trunk in next few months?Paulo

Hi,is it possible to have the same security level in two interfaces of a PIX?In this case i´m triyng to put security level 100 in two interfaces.ThanksAntonio Sobreiro

HiThis is the first time that i configured PIX! Pls help me.I configured PIX 501. All the pc's in the network, cannot access the internet (gateway is the outside ip add of PIX).Here's the config: KAJIMA# sh conf: Saved:PIX Version 6.1(2)nameif ethern...

I'm looking for help in configuring our IDS 2410 v3.1 to use our PIX for IP Blocking.IDS will sit and sniff between the outside interface of the PIX and our ISP's router. The management port of the IDS wil be routed thru a switch on the inside networ...

I am trying to install a pix 515 between my Sprint 642R router which is my adsl line and my network (which has a public address) I use the adsl to give internet access to the staff. Is there something about the workings of the pix and that router? Th...

I've got a 515 Pix Firewall that I wanted to check if port 110 was open because I cannot POP3 into our Exchange server. I never worked on a Cisco firewall so I do not know any commands. Could you tell me how to check this on the firewall and also the...

I'm intrested in PIX certification( CSPFA) for better job opportunity, but to get certification I need to clear four papers(MCSN, CSPFA,CSIDS,CSVPN). Getting training on all these are not possible due to cost/fee and location of courses.My question i...

Is it possible to configure the following:networkA(watchguard firewall) --ipsec-->networkB(pix)--ipsec-->networkC(pix) where connection atempts from networkA to networkC are translated to networkB addresses first so that connections are transparent t...

I am tuning the DFM to filter the alarms that I don't want to see. I am trying to setup "Expression Filering" in the DFM Console but I am not well versed in regular expressions. My problem is: I want to filter EVENT "Unresponsive" for CLASSES "Switch...