Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Anyway to provide Anyconnect users static IP from ASA, other than DHCP pool IP.Architecture is Anyconnect <> DC ASA <> DC ISE <> Corp AD Anyconnect users are corporate AD users. ASA sends requests to ISE and inturn to AD. ISE does some posturing chec...

manvik by • Level 7
  • 1544 Views
  • 1 replies
  • 0 Helpful votes

Hi All,  am facing some basic issue with ASA Nat on EVE-NG . I am not able to ping after using below mentioned nat statements, but I removed these NAT statements am able to ping ( Dst 10.10.44.100) from Src  192.168.20.100.  But at same time NAT Tran...

DEV1389 by • Level 2
  • 3138 Views
  • 5 replies
  • 0 Helpful votes

Hello All,Wish you Very Happy New 2021 we are looking to deploy anyconnect vpn in ios & android device.below is webvpn config webvpnenable OUTSIDEhstsenablemax-age 31536000include-sub-domainsno preloadanyconnect image disk0:/anyconnect-win-4.9.00086-...

Nitin S by • Frequent Visitor
  • 2076 Views
  • 4 replies
  • 0 Helpful votes

I'm new to FirePower Threat Management System. I got the FMC setup on a Dell server with ESXi. I need to update this server so when I do the FMC will not be available to the FirePower. So what happens? Does the firewall keep working with all of the s...

CiscoNerd by • Community Member
  • 3259 Views
  • 2 replies
  • 0 Helpful votes

Hi AllWhen adding certificates to the ASA for anyconnect access, how come we need to add the cert of the Root CA on there?what is that used for here?I normally add the identity cert as well as the Root.Cheers

Hi team!I have ASA5515-x and FTD2100. I'm willing to migrate from ASA to FTD so i used Firepower Migration Tool. ASA has one physical interface for each zone, but on FTD i want to create etherchannel for each zone for redundancy. Is it possible to mo...

Hello, I resetted the old ASA 5505 back to the factory results, but DHCP is still not working. Clients on port 1-7 dont get an IP address, I also renewed the network interface driver. The Gateway interface is on port 0. Do you have any suggestions to...

Hey dearest community! I have a problem with deploying any changes to my ASA 5508-X running FTD 6.4.0.1. I found out already how to create and display the deployment log (exper, sudo su, pigtail deploy).It is failing with any changes, regardless what...

Leon1 by • Level 2
  • 8354 Views
  • 7 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card