Other Data Center Subjects

Hi,  I am new with Nexus Data Broker.    I am using python to set new filters and connections rules on demand for our monitoring devices.    The issue is that any creation or modification actions that I am trying to do ends with 401 Authorization Req...

What  is the mechanism to secure the workstation to NXAPI on the Nexus 9000 running in NX-OS mode? How do you load certificates on the Nexus 9000?Python_Example(config)# nxapi certificate enableNginx certificate invalid.Thanks  

We have a DC setup like below : FEX-->N5K--N7K  N7K is where all VLANs are configured. Now customer want to remove N5K and replace it like this : FEX-->N93180-EX---->Nexus9504---->N7K I can understand that N5K config will be replicated on 9500 b...

  What does the suffix BUN stand for ?    what are the meanings of  suffix  " = " , " BUN " and " -  ?   N7K-SUP1-BUN"  ,  "N7K-SUP1- "  ,  "N7K-SUP1= "          

Hello Everyone   I'm having some issues while trying to run the HX Profiler on a vCenter. I've done this before on another vCenter and it was OK.   It looks like the profile can reach the hosts (it shows the number of the hosts that exists on the sys...

Dear NetPro gurus,I'm a newbie on Nexus.  Just curious for a customer who has Nexus 7000, what options can they use to link up to the Nexus 7000 in a LAN environment?? And since they have 3 multiple sites, can the Nexus 7000 be linked together over t...

Hi All, kindly need your urgent support regarding Hyperflex deployement. I have the following hyperflex design: - 2x6296 FI - 3x HX220C M4 I will be using the following firmware. Hyperflex: 1.8(1f) HX Data Platform Installer: 1.8(1f) UCS FI: 3.1...

Hi,Are you able to advise what has to be done to change a hostname?I made a mistake entering the hostname and I can't rectified it.  It came up with error "String failed to match token pattern at '^" marker".I did removed the entire config (write era...

Hi,   I've been asked to rethink the architecture of a small public Data Center which currently is equipped with only a pair of ISR 3900 and a Catalyst 6500 switches at its edge and core layer (no distribution). I've been scratching my head as to whe...

Are there CLI commands to do a factory reset of a new Hyperflex system?

I have two data centers connected via DWDM. In each data center I have two ASR's as OTV routers. The infrastructure is laid out in the attached diagram.   Each ASR has a 1GB join interface connected to the core and a 20GB port-channel connected to a ...

Hi,   I'm actually faced to a strange problem, I tried to connect a old firewall Cisco ASA 5510 (in transparent mode) to a Nexus 5572UP but when I do that I have many packet loss.  Can someone help me ?   Thanks!