Other Network Architecture Subjects

Hi,With the use of MIB, is it possible to obtain the real time value of CRC and input errors? It seems that those values are not real-time but are same as those found in "show controllers interface <if>". Also, do we have to use different MIBs for di...

We are in the process of installing two ACS appliances in our network. We have a Windows 2003 AD and when we go to configure auth is there a preference to use either the Wndows database or can we use generic LDAP? What would be the pros and cons of e...

This seems to be a common problem for most of us. We see only output drops ( on ethernet,serial) increasing and no other errors like CRC, input,input drops, etc varying.Cisco Doc recommends to use queueing techniques to overcome this problem. This pr...

I have RME 3.5 and a RADTAC tacacs server.I have created an acct =cw2k on radtac and set up the attributes in RME using the appropriate tacacs acct info.when I run the check device attributes applet, the value of INCORRECT is returned in the TACACS ...

When I tried to upgrade the IOS for 3660 router using xmodem, after finished transfer file to router, I got the error messge of "Ready to receive file c3660-js-mz.122-15.T9.bin ...Erasing flash at 0x30000000sector erase failed at location 0x30000000,...

Experiencing problems with negotiating the speed / duplex settings between a 4506 & 2691.A port on each device is connected to a 3rd Party Fibre running at 10Mbps/Full Duplex. I can manually set the relevant port on the 2691 to use 10Mbps & Full-Dupl...

Hi, I have a single 3750-smi. the box is split into three different vlan's - 100, 101, 102. I want to route between vlan 101 & 102 on the 3750. vlan 100 has a different default gateway to 101 & 102.QUESTION :1) How do i route between 101 & 102 ( i a...

Hello,I need to set multiport static mac addresses in the MAC address databaze of a Catalyst 2970 or 3750 switch. I see in the current configuration guide (IOS version 12.2(18)SE) that this is not supported. As far as I can see there's no such limita...

Is this possible?Having and Internet connection thru the 2610XM which connects to one interface on the PIX515E and then each switch connects to a seperate interface on the PIX. All equipment will have public IP addresses. Each switch is a different ...

Hi,We upgrade the main memeory for cisco 3660. And tried to upload the IOS to flash. But failed.I found the message on the following:"Main memory is configured to 64 bit mode with parity disabled"Did I miss something?JoeSystem Bootstrap, Version 12.0...

Hi,I am getting 2 MBPS from my ISP to the serial port of my router. I have two Ethernet ports. I want to give 1 MBPS to one Ethernet port and 1 MBPS to other Ethernet port. I wish to use two Ethernet ports for two different network. Please advice me ...

Hello All:Experiencing an odd problem and am wondering if it could be the line itself.Several T1's coming into the company. Corp side comes in through a 1721 router to a Sonicwall Pro. We have problems getting to GOOGLE.COM from this line but not a l...

May i configure the interface E1 (cbr) in point-to-multipoint mode ? If yes , how could i do it ?Because i tried to create a subif under the CBR interface but the switch doesn't permit this creation.

Have a 2610 with 3 interfaces, 2 were active before and I am turning up another. This router is placed external, I have another 2610 on the internal side.ethernet0 = LANethernet1 = Wireless ISP (just added)serial0 = T1My question is with routing but ...