I have two ACS groups, One has "PPP multilink" checked and the other not. But users from both groups are still able to establish an ISDN-dialup multilink. I want to deny multilink access to one group.I have added "aaa authorization network default gr...
on cisco 2610 router with 2 WIC and one eth module on which i have to distribute the internet of 512 Kbps in to 64 Kbps and 448 Kbps is this possible in 2600 series router if yes then how please help in this issue
I use Etrust Anti-virus and in order to centrally manage all the workstation on different subnets it discovers them by broadcast UDP packets on port 42508.Currently my Etrust admin server can see everything on it's local subnet, but can't see anythin...
Hi,I have a Cisco 7206 running Cisco IOS 12.2(17a) and it works just fine. When I upgraded to 12.3(3), it kept being resetted by "watchdog hard reset. The system would boot up, and I would get the "Return any key to get started" message, but after ab...
hi alli have an etherchannel setup between 3550 and a 3548. in testing when i disconnect one of the links it takes close to 10 seconds for the other link to start transmitting data from the test machine. i have data going over both links at all tim...
Hi,I have three classes define in CBWFQ. The class with the most traffic (batch transfers) is only allocated 10% of bandwidth, while real time/interactive traffic is allocated to a class which gets 65% of bandwidth. When the batch transfer class gets...
Our company need a device which can make a dvb stream from ip stream. After that this dvb straem we are going to deliver on space satellite for further broudcasting of ip traffic. Is cisco have a such device ?
Hi,I need to connect a Luminous E520 having 1310nm Single Mode IR GBIC tranciever with the CISCO WS-G5486 module 1000BASE-LX/LH, in a GE port of Cat 4503's sup IV.I assume that the wavelength of laser on both ends need to be the same. Please let me k...
We are trying to cross-connect a 7206 NPE300 router's FastEthernet with another ethernet device. but the line protocol does not come up. We tried to cross-connect the ethernet device to a 3640 router using the same cross-cable and it works.Are there ...
HiI have a 3500XL switch in my network that has a cpu usage that never goes below then 40% even when theres no traffic. When the traffic rate is higher it gets higher then 40% but it never gets below this number. The switch works fine and theres no p...
I have a Cisco switches 6503 with supervisor MSFC2, IOS version 12.2, pcmcia ATA card 64 Mb, rommon 7.1(1).. File installed cat6000-sup2k8.7-2-2.bin And when I try to copy the IOS in the ATA card, or format the ATA card: Format slot0: Or Format disk0...
Hi,We have 5 Qty of 3548 Switches cascaded together using gigabit stack (Switch Model WS-C3548-XL with IOS 12.0 ) . The Giga port 0/1 in Switch-1 is uplink 6509-1 and Giga port 0/2 in Switch-5 is uplink to 6509-2 . HSRP is enabled in both 6509's . ...
What is the description of CDP TLV 0x0012, 0x0013, 0x0014, 0x0015 and 0x0016?for example type 0x000a is "native VLAN"Is there a document that describes the newer CDP TLV like the one used for in-line power consumption, etc?ThanksAriya
