Good afternoon,
I have a quick question for everyone...I am testing SharePoint 2013 behind WAAS and it works great except...I cannot upload documents via drag and drop. Regular file upload works fine.
Has anyone run into this before? This is ISR-...
We have installed a Cisco UCS-E160D-M1/K9 in Cisco 2921 and the devce is not recognised.
Sh inv
NAME: "Unknown on Slot 1", DESCR: "Unknown"PID: UCS-E160D-M1/K9 , VID: V02 , SN: XXXXXXXXX
IOS Running is c2900-universalk9-mz.SPA.154-3.M4.bin
Base...
I'm trying to install Palo Alto v5 MIB files (sourced from https://www.paloaltonetworks.com/documentation/misc/snmp-mibs.html ) but when I try to install, I'm getting a system error popup, but the popup doesn't have the full error message for me to d...
I recently upgraded my ASA 5505 software version, but didn't like the configuration. I executed a write erase and reloaded, but now the ASA is repetitively trying to reload with no success. I get the following:
Platform ASA5505
Launching BootLoader....
I am trying to upgrade the image file of an ASA 5505 using Solarwinds TFTP, but the ASA will not communicate with the TFTP server.
The ASA can ping the PC running the TFTP server and the PC can ping the ASA. I've checked to make sure the file is in t...
Hello Everyone,
In Switch 6807 , i am observing some logs kindly find the below log for refrence.
==============================================================
%SCHED-SW1-3-THRASHING: Process thrashing on watched queue 'FM Inband ReplyQ'. -Process=...
Hi Support techs,Am going to ask a silly questionCan you add your ISP into your routing table or is this just for subnets etc to communicate to the outside world?If so. Can someone give me a link to do thisI have a 2691 MPS routerIOS is C2691-IPVOICE...
Hi all,
Want to know the sample eBGP configuration about how the trasit provider announce the full ,partial and default routing table (BGP) to its customers.
Thanks
I have a simple config (posted below) with 2 VLANs. I am dealing with bad software that I can not tell it what IP address to output on. I have 4 multicast IPs that will broadcast on one or the other VLANs. I want these 4 multicast address to be on bo...
Hi Guys,
Nexus debug
SW1# dir debug://sup-active/ 20946944 May 24 03:12:52 2015 processmib_debug.log
Usage for debug://sup-active 20971520 bytes used 0 bytes free 20971520 bytes total
The content are all similar.
<Sat Mar 21 18:37:29 2015> create_...
Hello,
i am planing to buy a network design tool for the partner presales and design actvities .. could you please recommend one or more tool - i have already tried the NetformX Design Expert tool .. please recommend any alternative tool
Best ...
Cisco 4948 -- Link up Link down traps - Missing Trap Components
Hi Guys ,
While simulating traps via making a link down and again up , Cisco 4948 is sending the OID 1.3.6.1.6.3.1.1.5.3 to our monitoring device .But it seems below variables /trap comp...
Experts, I tried searching doc on cisco and even googled for information on how much bandwidth netflow export uses; however I didn't find any convincing article. I also found lancope.com where they estimate the BW required, but still I was not satisf...
Hi all,
I have the following conf on my router:
class-map match-all NBAR_NTP match protocol ntpclass-map match-all NBAR_DNS match protocol dns
policy-map DNS_PREC class NBAR_DNS set ip precedence 4 class NBAR_NTP set ip precedence 3
The policy is a...
