Other Network Architecture Subjects

I want to know whether the usage of Frame Relay PVC Bundles and Low Latency Queueing for Frame Relay is mutually exclusive?My provider offers me a bundle of Frame Relay VCs with different class of services and I need to know how to use them effective...

I'm using catalyst 6500 with OC-12 ATM lane module. How many le-arp entry can manage simultaneously an OC-12 ATM module ??What's happen when le-arp cache is full ??

HiI am having a problem with a 1601 Router. The line protocol goes up and down. I installed another WIC 1T to test if the problem was on the Existing WIC but still have the same problem with the new one.The IOS version running is 12.0 (3)T . Also whe...

I have a 2924M-XL & a 3750G switches. Port 1-4 are configured with Etherchannel on both swithces. When you issue the "sh span", the 3750G shows that all pors 1-4 are on FWD mode but on the 2924M-XL, only one port is in FWD mode. There are no detai...

Does the cat 3524xl support QOS?What are the configuration commands for on this switch?

In my 3640 router ethernet 0/0 port , collision is incresing like anything. Please suggest any one , how to slove the problem.Note: i have 11 VLAN's in my Campus switch. Campus switch is 6009.Router Report is below: 15293869 packets input, 157812953...

I am running on ADSL connection using WIC-1ADSL and have a couple of fixed IP addresess allocated to me by my ISP.1st question ,Is it posibble that i use 1 ip address to do PAT like "Ip nat inside source list 101 interface dialer1 overload".2nd quest...

I have two 3660 connected over a Fastethernet connection (using a wireless laser). The routers have 100Mbit connection, both CPUs are 4%, I use IP only but the bandwidth utilization stays below 2Mbit.Do you know if I have to do something to speed up ...

On the older ios of the 3550's I used the cmd switchport priority extend cos 0 for interfaces connected to ip phones and pc's. I now am configuring a 3550 with newer IOS and this cmd does seem to be there. when i do a show interface switchport fa0/1 ...

In the process of hardening my router and network I've shut down all configuration ports except the serial console. This effectively eliminates my ability to configure my router from the outside. However, is there any way that I can SSH to the rout...

I am running eigrp on my network. Why my core switch (4500) takes least optimal path even though my primary link stays up but all hqs traffic start going through backup link which is 128 kb. My primary link is 45 mb. I did not see any eigrp log messa...

Hi, I am getting the following error message pop up in a dialogue box when I try to access any of the functions after logging into a fresh install of nGenius 1.4 "nGenius Traffic Monitor" is not currently licensed. Please contact your sales represent...

Hi guys, Can any of you guys clarify how a SNMP ping differs from ICMP ping.ThanksDinesh

2514(2 ethernet)1st ethernet: 192.168.0.6/242st ethernet: 10.0.0.1/8my PC: 192.168.0.3/24in my pc, how to ping 10.0.0.1