Other Network Architecture Subjects

Dear all,I'm not sure if this is the correct forum for this query, but here goes anyway.We are looking at installing 2 x 4507R core swithces. Both units will run 2 x Supervisor engines which will have both GB interfaces connected to each unit (will b...

I just purchased a CABV.35-SS-MT cable and seems what interface card should I use?WIC-1T seems like not fitting.

I need to have my router reboot every hour on the hour. Does anyone know how I can do that?

I have a question on what is the time interval for exporting the Netflow data to the collector from the Cat6K / Cisco IOS routers!I cannot find any documents about the time interval.Thanks,

Hello All! I would need some help to understand netflow. I read all cisco documentation but it`s still not clear. Too focus at the command level and not enough at the architecture level. I have a vlan where I want netflow active so I include in t...

Hi,I am facing a problem in cisco 6006, cisco 4006 and cisco 2950 switches and where i am unable to log messages to the ciscoworks 2000 server. The same situation is also for cisco 1538 hubs. But i am able to log messages generated from cisco 3548 s...

My main ISDN line is down temp,I have a few workstations planning to use normal diap-up,it is mean I need to purchased the WIC-1AM to connect to the RJ-11 phone line.Anyone have sample of config which can posted here

I realize that this is a simple problem but for some reason I can't figure it out and feel very stupid. I am setting up an ITS router and it tells me to copy some files to flash about 8 or so files. But when i issue copy tftp flash and then enter in ...

Hi -We are using Cisco 1721 routers for Internet access. We have 2 of these 1721s each connected to its own frame-relay T1 via the internal WIC cards.We are noticing that there are some IP addresses that we can ping from the routers via the console p...

Hi,I'm quite new to QoS technology. Can you please let me know what is IP precedence , DSCP vales ...regards

Is the port priority is only applicable to root switch? I was trying to change the port priority of a non-root switch and it doesn't change although it reflect on the config file.Any suggestion is appreciated.Many thanks in advance

we have cat 6500series switch.fastethernet ports we are assin swithport security max-1.but the port is automatically shuts down.and again we have to make it no shut.what could be the problem.

Dear Friends,can u give the exact and illustrative difference between CIDR and VLSMregardsManish