Hi,On the RSM module, how do I clear the statistics on the buffer and On the ATM module, how do I clear the statistics on the buffer and controller?TIA.PF
I have this issue:R2: running area 0 and 3 (ABR)R1: running area 3 only (Internal router) and also is ASBRI created a loopback interface on R1 assign ip address 150.50.200.1 and thenadvertise this network in RIP. I then redistributed RIP into OSPF,...
I have a Cisco 1720 router with leased line to internet and ISDN backup to internet. The ISDN backup is using "Backup interface" method. My ISP assign different IP pool for my leased line and ISDN. So I use route-map so that the router will select ap...
Hi All,In 3550 manual, cisco said that you should use "flowcontrol send off"and "flowcontrol receive off " first before you use "mls qos"command. But I had seen serval sample and none of them use the "flowcontrol"command. Can any body have idea that?...
I have a cat 4006 connected to a PIX 525 on the DMZ interface. the PIX is running IOS vers 6.1. The 4000 is running cat os 5.5.(10) at layer 2 and IOS version 12.0(14)W5(20) on the router card (WS-X4232-L3). For the past three days I've been noticin...
Hi, I have read in documentation and in conversations, that if I aply an ACL in a sub-interface PORT-CHANNEL it won't work, but I have tested and worked.Instead the IOS report that don't support the command, its works. Down what happened .Can anybody...
We have a MAN with 7 routers connected to a shared 100MB fiber ring. We need to run cdp to see the connections between these devices. The problem is our service provider has a Cisco network management device that can only run at 10 MB/half duplex. ...
Hello,On the url: http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-cd-one I could find the patch cwvms-common-services-1.0-p1-win.zip. How I know I need the common services with VMS. But what is the reason to put this patch with the cd one patches? ...
I have 1 site dialling into another site on backup and I cannot get the ppp part working. Debug output shows the following:-Apr 1 13:52:19.533 GMT: BR2/0:1 LCP: State is OpenApr 1 13:52:19.537 GMT: BR2/0:1 PPP: Phase is AUTHENTICATING, by bothApr ...
Can anyone tell me (or point out a cisco url) that mentions which process belongs to which module ? My reason being, I have CM installed along with RME,DFM etc and I want to stop CM but not to uninstall. So I want to just stop all the processes asso...
How is this done? A good example is at many public Wireless Hot Spot is to aquire an IP and then fire up your browser. No matter what your start page is the browser goes to the providers Web page to login, signup or whatever. Is this done via soft...
I have a 2611XM router with nm-16am (16 analog modem).What are the real capabilities or benefit of the MMTL (Modem Management Technology License) ?Thanks
I edited the apache httpd.conf file and changed the CiscoWorks default port from 1741 to 80. However the login page still references port 1741. Anyone knows how to fix that?
Hell-o,Trying to come up with a plan to convert our addresses behind our firewall from a 10.0.0.0 255.0.0.0 to 10.0.0.0 255.255.255.0 in stages rather than all at once.Presently we have 25 network segments all connected to a 2980g switch (flat).We w...
