Other Network Architecture Subjects

I am having trouble accessing my 2924 switches through HTTP. I am using windows 2000 and internet explorer and have installed the java application needed. I am asked over and over again to enter a username and password while the graphics are loadin...

HELP!!! I have had quite a frustrating day today. I have four US robotics 33.6 external modems. Three are new and one is one from 1998. I can get the old modem to work connected to the AUX port of a 7206 just fine. With the other three I am able to c...

If I enable the use of reliability in the metric calculation for EIGRP, will DUAL kick off when the reliability of an interface changes?I have two sites connected w/ two equal cost PVCs on seperate circuits. If one of these circuits begins to have p...

I have a 2612 router that I am troubleshooting for an intermittent problem. The configuration is a very basic IP configuration using EIGRP routing protocol. Nothing special.However, when I do a show interface on E0/0, the input queue shows "-1/75"....

Trying to get CiscoWorks 2000 running for the first time. So far, no luck.I loaded all the CD's on a virgin Win2K Pro box using all the default configuration options. I can launch CW from my browser and login without any errors.In "Server Configura...

We are purchasing the LMS 2.1 and I would appreciate any recommendation or the lack of thereoff on getting the SAS with it.Thanks

why when we demand https://pixadresse it's so long , so long so long ???

Starting with PIX 6.2, NAT and PAT can be applied to traffic from an outside, or less secure, interface to an inside (more secure) interface. This is sometimes referred to as "bi-directional NAT."So If all Internet outside addresses are be "bi-direct...

If I am not using dns on my Ciscoworks server, or using dns resolution for my networked Cisco devices, is there a way to get RME, DFM and CiscoView to use the snmp sysname of a device instead of the 'discovered' ip address of the device. I know Camp...

We have two catalysts 6509 with two msfc2 cards each runninghsrp. All these 4 routers are being monitored using MRTG. After upgrading two msfc2 cards on the first catalyst 6509 to IOS 12.1(13)E , both of them stopped responding to snmp request,for...

Can anybody tell me how to enable startup time logging inCisco Routers /switches.I want to log the time when my Routers and Switches come up.Regards,Anil Aravind

we are trying to overload from inside to outside and from outside to inside. Why i´m not able to add the syntax "overload" in the statement: ip nat outside source list XX pool yy "overload" ios c2600-is-mz.121-17.binDo you know if there is any explan...

This is partial output of show versioncisco 2620 (MPC860) processor (revision 0x102) with 53248K/12288K bytes of memory.the router has 64 mb ram.is the 53 mb / 12 mb division for processor/ io memory ???Isnt this value for io memory (12 mb)??If yes,...