Other Network Architecture Subjects

hi alli've read the following on ccoSupport for dynamic VLAN assignment provides flexibility in assigningports, enabling users to move toanother location/port on the network and retain the same VLANHow does this work?In my mind vlan assignement was m...

Can someone tell me why this happens ? what is wrong with my configC:\>ping 165.21.x..xPinging 165.21.x.x with 32 bytes of data:Request timed out.Reply from 165.21.x.x: bytes=32 time=55ms TTL=247Request timed out.Reply from 165.21.x.x: bytes=32 time=...

I have an ATM wide area network with four sites. This used to be five sites but one was removed recently. Since removing the fifth site, and all configuration regarding it from all ATM switches and routers, I get this error message every 30 seconds o...

I cannot get a connection up between a 2500 and a Compaq Tru64 DS20 running Unix 5.1a, with a Digi Fire 2000 WAN card, using a X21 cable (DCE at the 2500 end). On the 2500, the int is up/down. If I put a modem emulator between them it works fine, (25...

Is the mls disabled if I use any of the IOS FW features in a Catalyst 6500 with sup1/msfc2?Where can I found all the features supported in this IOS fw for the Cat6000?Thankyou

Hi,I would like to know if I can I save a database vlan from 6500 switch ( with native IOS ) to RME 3.3.Other question : I would like to know if it is possible to adapt the vlan database saved ( in automatic mode ), to put it again into the databas...

Hello,I have an AS5300 with this version :IOS (tm) 5300 Software (C5300-I-M), Version 12.2(1c), RELEASE SOFTWARE(fc1)Can I use NetFlow features in proper condition ?Best regards,Sorin PARLOG

Wanted to know if any one had sample config for setting up PPP Mulltilink on Channelized DS3 using PA-MC-T3 and 7507 on one end and 7204 on the other end. Thanks in Advance!

Hi, what does " dispose ip.notgateway" mean ? IP: s=10.63.100.175 (VLAN1), d=10.63.101.255, len 229, dispose ip.notgatewayThanks

I am trying to configure HSRP with ACL's Box: 2 x 6009 with MSFCMultiple Vlans with HSRP (works without ACL)Issue: e.g Extended ip address list <xxx> permit ip<subnet> host 224.0.0.2 (Matches) Ex...

I have a number of 2950-24 switches at Version 12.0(5.3)WC(1) which reboot roughly at the same time each day. Being distributed over a WAN, this points to the Cisco Works polling as the initiator.Does anyone have a solution to this?

i would like to know how to disable the write-protect on the pcmcia card in 1603 router.When I tried to copy new IOS to flash fron TFTP it says "PCMCIA card is write protected,cannot erase". But I was able to copy old IOS from flash to TFTP. The flas...

Hello,I checked the doc and it seems that the Cat3550 doesn't support private VLANs like the Cat6500, but there is another feature called protected ports. Can someone confirm me tthis?Thanks in advance.Rui

Hey Group,How do you go about determining what the pps rating really means? I normally have just 'shotgun' designed small router configs based on the number and type of interfaces I needed, but I'd really like to know of a somewhat more scientific m...

I have gotten the error-message "%SYS-3-EOBC_CHANNELREINIT:Ethernet out of band channel reinitialized (1)" once on a 6509 with dual sup2 running version 6.3(8)Tried to look at the system message guide documentation, but it's not included there.Does a...