I have a router 3640 with VOIP configuration and already have some command for QOS.Now I want to implement CBWFQ for bandwidth reservation of certain subnet do I need to remove the existing QOS command or just I can add the comand require for CBWFQ.
we want to use two Quad E1/PRI into one AS5300. the software is IOS Version 12.0 (7). the first one is build in slot 0 and we want to put in the second one in Slot 2. the slot 1 is occupied by Mica-Modems.at the reboot after the build up we see the ...
If I use the IP extended command to filter to tcp port level e.gaccess-list 101 permit tcp host source IP address host destination IP address eq 23 , and apply it to a port using incoming access group , does the port number 23 apply to the source IP...
I find CE1 interface up down frequently, and use "show logging command " to check error message , thereare many lines of PPP Serial1/0:13: exceeded max retries taking LCP down.PPP Serial1/1:20: exceeded max retries taking LCP down.PPP Serial1/1:18: e...
All documentation relating to switching states that a switch will forward a broadcast on all ports. Am I right in assuming that a switch will not forward the broadcast on the port on which it was recieved? - I'm trying to understand why a broadcast p...
I want to I-mux 6 Serial T-1's using a Cisco router. The web page is not clear on router requirments. Some links say only a 7500 with certian VIPs support the feature, but other docs picture 7200's. Will a 7206VXR with either and NPE300 or NPE400 I-M...
Our 3640 works as a firewall. We have a couple of Nat translation entries:2 dynamic ( one to internet, the other with overload on the route to the partner company in London)We want to add static translations with the route map to allow a few internal...
I am configuring an ISDN dialer backup, all works ok with the following static routeIp route 0.0.0.0 0.0.0.0 172.16.40.5But will not work with the following static routeIp route 0.0.0.0 0.0.0.0 bri0I get do a debug ip packet and get an encapsulation ...
We have ascertained by testing that we can only achieve about 512k max throughput on an ML-PPP configured ISDN backup link. We need to be able to provide full E1 backup speeds, but have Cisco resolved the issue above, or maybe there is another solut...
We are using virtual-profiles to assign access-lists via radius on a ISDN RAS connection.We set the session idle-timer to 300.When the connection is established I see two Timer ( "sh user" virtual-interface and serial-interface). When traffic is send...
