Other Network Architecture Subjects

I have a frame network in a hub configuration. The hub site also has a frame connection to the Internet which the remotes use (if I can get it confgiured correctly). The remote sites can see the internet when I do a "show ip eigrp topology" and a ...

dear,I hsve a modem ADSL (alcatel) attached to an ALCATEL DSLAM ...the dslam is attacched to an LS1010 to port atm0/0/2 ... on the port atm0/0/3 is attached a router 3640.id like to make a PPPoA connection beetween the modem alcatel and the 3640.Is ...

We are currently routing over a T1 connection using a 3620 router (current host location with 16 remote branches) and will be adding a new location which will become our host location over a DS3 connection within a cyber center also using a 3620 rout...

With a Catalyst 3524, if i run the command"sh env all"i get info about the fan and the temperaure of the switch.1) how can i get these value with the snmp ? (no command like "snmp-server enable traps envmon" is available)2) the command "snmp-server e...

Trying to enhance an existing infrastructure with a Cisco RAS product. Site currently employs a 3COM device. This product must stay in place, while the Cisco will be temporary until a Cisco VPN product can be deployed. Is the AS2511-RJ the best way t...

I am running a Java based FTP application on a Sun Solaris platform. All of my connections have been across dedicated, networked links. I now have a requirement to dial out to a number of remote sites that have RAS servers. Is there a Cisco device th...

Is it possible (and how it is!) to agregate two serial ports of a WIC-2T card to double the bandwith on a 2650 ?

Hiwe have another company trying to connect to us. they use netgateway on aixThis is their config, then follow our config. isdn debug at the endThey dial in and the connection is immediately disconnected.Any ideafrom netgw config isdn_IMCAM { ...

After restarting the 5005, my route switch has (boot) after the hostname. Can someone tell me why?

Hi,We have OSPF area 40 and we have also defined the following static route.ip route 0.0.0.0 0.0.0.0 fastethernet0/1ip route 10.20.30.0 255.255.255.0 10.20.40.1People are not able to see 10.20.30.0 network from other side but after redistributing sta...

Is there a disadvantage of assigning a 30 bit mask to an ATM interface which is part of a ATM backbone using Multipoint? With a hub and spoke design serial links are commonly assigned 30 bit masks to conserve IP addesses and reduce routing table. I...

Hi AllI have configured sna before and have in the past connected the sna controller to the router with a db60 to rs-232 cable. This seems to work ok on a 2600 and this is the output I have from sh intSerial0/1 is up, line protocol is up Hardware is...

I am trying to connect a 1602 router to an ISP via a PPP connection. On the 1602 end I have a Serial WAN interface card hooked up to a modem via a CAB-232FC cable. My questions are: How do I configure the router to make the call to the ISP and con...

hi, i've read everywhere that you can use the "cost" option on dlsw commands to force routers to prefer on peer over another.also i read that if i use the "cost" option on a "dlsw remote-peer" command it'll overwrite any cost sent by that remote peer...

I removed a NAM from a 6509, but the device keeps appearing in DFM. Deleting the device in the admin console doesn't seem to work, as a reboot causes it to re-appear.Any ideas??