How can I check CPU utilization on 5505, not the RSM module but the switch side of it? I am running ver. 4.5. I am sorry I could not find it on Cisco's web site.Thanks,
I need to know if there is a way to have say 4 or 6 ports on a Cat 4006 act more like a hub than a switch. (Kind of like the old Cat 5000 group switching cards) We are having problems using Windows Load Balancing and the only way to fix the server-to...
I was wondering I know you can do DHCP with a 2600 for SLIp and PPP connections via a router. But can you assign Addresses via DHCP via a 2600 router to computer on the LAN. Much like a NT server would. What we are wanting to do Is seperate one netwo...
HiI have problem with one serial lines.The link it worked properly, but when I try to use the ppp reliable-link command in the serial line configuration, the link is going down, and thenit's never becomme up with initial configuration.On the other s...
What is the easiest solution for solving the following problem......Two networks are coupled but each network have it's own DHCP server. Clients(when booting) requesting for an IP-address, will receive this either from the DHCP server A or B, the one...
What ratio of global/private addresses can be considered as acceptable in Dynamic NAT. This is assuming typical ISP service offerings. Also, what are the main advantages of Dynamic NAT over the overloading.Help on this will be much appreciated.
We are building a WAN with aprox. 124 sites and 350 concurrent users running off of a Citrix farm.The total bandwidth is 10Gb (CIR 5Gb). The largest connection is 128Kb (CIR 64Kb).We have had various recommendations made for equipment (1720 or 1750 ...
I have a UUNet T1 which is billed on a monthly aver. usage. I need to try and keep your usage down below 256k to stop excessive charges. Is there a way to throttle down the bandwidth on an interface?Cheers
I wont to see the utilization I'm getting from one of my t-1's. What is the best way to check the utilization of this line. I understand I should run the test against the CPU of the router. But how exactly do I do this? I would like to collect data o...
Is it possible to have multiple default routes on a 2948g-L3 switch ? If so, will it serve as a redundant link ? ie will traffic only go through one link unless the link goes down .
Hello,Can anyone tell me the difference between mls and mls rp on a Cisco 6509 supervisor card?I've noticed that the sh mls status shows global mls ipx as enabled but sh mls rp shows ipx multilayer switching as globally disabled.Many thanks, Lee.Mari...
