Other Network Architecture Subjects

Hello, I am using a Cisco 1720 with IOS 12.0.5(T1)with Firewall features and I want to be able to log packets rejected by access lists, without using the command "debug ip packet 102" because that creates an unnecessary CPU load.But by now it is the ...

Hi all,We have a customer who has a cablemodem connection to the internet. We advised him to use a cisco 1605 with 2 ethernet interface to support multiple client over the same internet account.The cable company uses DHCP to give there clients an ip-...

Can MLS be turned on on VLANs of 6509 MSFC, where NAT is also running on these VLANs? if not, is there any work around? Please advice. Thanks!

We have set-up a fiber to the desktop cabling system with SC connectors(no CAT 5 or 5e). We are setting up two (2)IBM x-series 130 web appliance servers with two (2) IBM Z-Pro Intellistation workstation, two(2) older pentium 166 MHZ and pentium 200-...

Is there anyone that can help..cheap or free

Can anyone give me a config that allocates a DHCP address to a device based on it's MAC address.I have tried the follwoing but it does not work. It says no address available:ip dhcp pool Mars host 172.16.2.254 mask 255.255.255.0 hardware-address 02...

Can I telnet to a 7204 and find out if the 64M of memory is made up of 4 x 16M SIMs or 2 x 32M SIMS?

Hi Say a customer with router RTA is connecting toa single provider with 2 link ,terminating at RTB and RTC respectively . eBGP between RTA and RTB , eBGP between RTA and RTC . RTA recieve just a single identical route (say192.213.10.0/24)from RTA an...

Is there a plan to have PPPoE Client feature for the 2514 router?

Can I sniff with the 3810 - I'm trying to trace a BootP request from a client ?

Why, when I do a "show ip nat translation", do I sometimes see a local inside address and a local outside address, but no port numbers (I am running overload) and no global inside or outside addresses? NAT usually runs correctly, but every once in a ...

does anyone know a NM for 36xx for transparent E3-traffic (non ATM!!)

Does anyone know the command to clear/reset/zero the stats shown when you do a "sho atm int a0/0/0" on an LS1010 switch running IOS 12.0(1)a0/0/0 is an arbitrary valueThe field I am particulary interested in is the AAL5 CRC Errors field. AAL5 crc err...

Not having a 6509 handy to toy with, does anyone know how the MAC address assignment works? Can you change the MAC on each Blade or is it limited to the chassis? I crawled through all the standard documentation and couldn't find a clear answer....

question is whether the router can use rip2 as the main routing protocol not eigrp when it use floating routing to backup a main link.