Other Network Architecture Subjects

Hello,After I've configured a Cisco 1700 router with the ADSL wic module installed, every X seconds a strange error message appears:%DSLSAR-1-DOWNGRADEDBW: PCR and SCR for VCD 1 (8/35) has been reduced to 160k 160k due to insufficient upstream bandwi...

Two AS2511RJ (12.0(7)T) configured as PAD's (autocommand x28 profile ... noescape) connected to different target X25 routers (S0) . Problem: One target router is down; Is it possible to route PAD calls to another AS using XOT only when serial port i...

Does anyone know what function is the "set port <mod/prt> debounce" command used for?

What are the minimum supported requirements for a DC3 ATM line? I had one CCIE tell me a 2650 would work and another tell me that I needed a 3620.

We are migrating the core of our WAN network from frame relay to ATM. The WAN backbone consists of 7200VXR routers connected to IGX8410s over ATM/OC3, with the IGX8410s interconnected via ATM/T3. A large number of small remote sites will be connect...

How would I connect to another router (ubr 900) series from 1 cable provider to another? Some type of IP route statement?

I have just been tasked to add dialin modems to our network. We have various cores, mostly 6509's within the UK. My proposal was to configure the switch for dialin but I aslo want to add some security. Would a dial back solution be sufficient. If som...

Hi Friends,Could youplease snd me CBWFQ sample configuration or class-based shaping configuration .Thanks

Hello, I am using a Cisco 1720 with IOS 12.0.5(T1)with Firewall features and I want to be able to log packets rejected by access lists, without using the command "debug ip packet 102" because that creates an unnecessary CPU load.But by now it is the ...

Hi all,We have a customer who has a cablemodem connection to the internet. We advised him to use a cisco 1605 with 2 ethernet interface to support multiple client over the same internet account.The cable company uses DHCP to give there clients an ip-...

Can MLS be turned on on VLANs of 6509 MSFC, where NAT is also running on these VLANs? if not, is there any work around? Please advice. Thanks!

We have set-up a fiber to the desktop cabling system with SC connectors(no CAT 5 or 5e). We are setting up two (2)IBM x-series 130 web appliance servers with two (2) IBM Z-Pro Intellistation workstation, two(2) older pentium 166 MHZ and pentium 200-...

Is there anyone that can help..cheap or free

Can anyone give me a config that allocates a DHCP address to a device based on it's MAC address.I have tried the follwoing but it does not work. It says no address available:ip dhcp pool Mars host 172.16.2.254 mask 255.255.255.0 hardware-address 02...

Can I telnet to a 7204 and find out if the 64M of memory is made up of 4 x 16M SIMs or 2 x 32M SIMS?