Other Network Architecture Subjects

I am having trouble configuring the IP for a 2500 series router.I am trying to connect the network 10.0.0.0 /24 with 10.0.2.0 /24 with a serial network of 10.0.3.0 /24 in between (We have a WAN simulator providing this)My problem is that when I try t...

Hi, can someone please provide me with the SmartNet Category for the Catalyst 6513. Thanks, Richard

I have configured cisco routere 2610 for FR connection on 64 k BW . I have noticed that there is a delay in traffic movemnet and its better if configured for IP. is there any reason ??fawaz

what's the difference between duplex full and duplexfull-flow-control, which has the better performance?thanks.

I want a BRI or dialer interface to go to state Down when the router fails to dial-out.This is for HSRP to track one these interfaces and then to activate the standby router to call-out on a different isdn-2 connection.I use the commands standby trac...

Hi All.I have just one point to understand in access list.I have a client place where I have installed a 801 for LAN connect.The requirement being that the users from outside ie the internet.I gave the access list as follows.interface BRI0 no ip addr...

What is the password recovery procedure for the DSC cards in the 5800 shelf???Or link to a page?

I have installed a Cisco3640 router with 2 modules NM-8AS. The NM-8AS modules have their interfaces configured either synchronous or asynchronous. The strange thing it happened is: while async interfaces is working fine, the sync interfaces is not wo...

Anyone seen this before? I deleted some vlans from a trunk (FE - 5500 to 5509) using CW2000 but the vlans stay in forwarding state on both ends of the trunk. (see below)After this, good old cli command 'clear trunk 3/1 1-1005' doesn't help. Even dis...

I get the following when trying to create a vlan interface on a RSFC in a 5500/Super3G (CatOS 6.3.2), RSFC is IOS 12.1(9)router(config)#int vlan ? <1-1000> Vlan interface numberrouter(config)#int vlan 1000 ^% Invalid input detect...

Does anyone know if any version of IOS for the 7513 supports a BVI w/IRB on an interface encapsulated with 802.1Q? Is this possible?

When I do a show ipx route, one of the entry looks as follows: NXH 3006 [12][**/**][02/01]What does the H stand for and what are the **? It disappeared from the routing table a minute later, but I'd like to know what it means.

Need to know how to create a user that only has access to content flow monitor? Also, why are virtuals not showing up in CFM?thanks

Cat6509 has both ethernets and atm modules installed.I can successfully monitor (via NAM/Traffic Director) all ethernet ports/vlans, but neither atmports nor virtual int of MSFC appear in the list ofports discovered on the switch. E.g., when roving f...

we have succesfuly installed the CVM over CISCOWORKS2000 with the default ports : 1000,1001,162 respectively for server port, poller port and traps port. the problem is that when running CVM module in CISCOWRKS2000 we are anable to log to the CVM ser...