Hello. I have hopefully an easy question. I am implementing port security on our switches. I tested it out in our lab on a 3524 with 12.0(5)XU. It works fine and send snmp traps when I violate the security with a differant mac address. My question i...
hi,i have one ACL applied on a router interfacewill a traffic in the opposite direction and matching the statements be allowed to pass?what if it does not match them?example:router(config)#access-list 111 deny tcp any any eq 23router(config)#access-l...
Imagine I have the following:RouterA, s0=193.10.1.1/24EIGRP AS#100 connected to RouterB, s0/0=193.10.1.2/24RouterB, s0/1=150.1.1.2/24Connected toRouterC, s0=150.1.1.3/24OSPF process ID 300Area1 configured as stubFile showing Configuration and show ip...
We have an Avaya PBX Medpro board plugged into a 3750 port with the following configuration:interface FastEthernet1/0/4description PBX Medpro-1switchport access vlan 10switchport mode accessduplex fullspeed 100srr-queue bandwidth share 10 10 60 20srr...
Dear All,I have 6509 switch. In its first slot present 10/100 ethernet module is there.I have to remove this module and insert 10/100/1000 ethernet module.Can I have some valid suggestions:1 Like these are the precautions needs to be taken2 Like Thes...
Hi, I'm setting up a pix 501 IOS 6.3 which has a dynamic IP assigned from our ISP router.I've the line in the config "ip address outside dhcp setroute" so I can see its getting an address assigned when loking at router config.Do I need then the line ...
Hi,We have two PIX 515E firewalls working in HA mode.I wanted to configure telnet access to firewalls from outside interface.PIX version is 6.3(5)I kept PC outside to outside interfaces.PIX outside IP is 10.10.200.3, inside IP is 10.10.202.5 correspo...
I am having issues applying a Quality of Service policy to a number of 2950 series switches. I am aware of the limitations of the 2950, but I am hoping to work around these.The problem synopsis is as follows:The customer has a number of 2950 series ...
Exceeding Engineering LimitsHi, I am trying to put together some documentation explaining what happens when some engineering limits are exceeded for the following metrics. Although I am familiar with a number of these metrics, there are many I am not...
My 2620 router took a power hit today. When I got the router back up the config register had changed to 0x2142. Does anyone know why this would have changed
Working with IPv6 and I received a return code of H. Anyone know where you can find what all the values for the ping reply mean including the H above?Thanks,
