Hello, We are considering running BGP between two ISPs on a cat 3750-G. This would be to control both inbound and outbound routing to our site. Before you say it, I know this isn't the best idea in the world but it's what we've got. Hopefully by ...
I do not have a module in front of me to check.Is there a document on CCO showing the location of the bootflash and DRAM on the WS-X4516-10GE SUP V card? Are these removabale or fixed? I have been through the complete documentation road map for this ...
I have a 4510R with dual redundant Sup V 10GE engines. This is on a lightly used network.I have done a show tech support and forwarded it to Cisco. Being as this was done though on the "failover" engine much of the most relevant info is not there. Th...
Hello dear colleagues,There are a lot of different ways to account for traffic. I would be happy to know the most efficient, reliable and preferable way to account for traffic (e.g. Internet traffic in a local network).- RADIUS accounting. Not very i...
I managed a couple of Cat 4000 series switches running WS-X4012 Supervisor Engine I. They run CatOS which I despise. Is the Supervisor Engine I capable of running IOS. If so how would I go about making the conversion? thanks,Chris
I am using an X2-10GB-LR 10 gigabit singlemode xceiver in a Sup V 10GE engine. I am getting low levels across my link. I would like to know if there is any means of optimizing the optics. Via software or otherwise. I have verified that I am transmitt...
Hi, i have a few LRE connected clients. The work well at a few Mb/s for for instance FTP or HTTP but when a user starts his/her MS office on a remote server, troughput suddenly seems to be down to a few kBytes/s for that protocol. Same for database a...
Hi,I have 1100 and 1200 access points connected as root bridges on cat4503.__________________________________The Gbic interfaces on cat4503 are configured like this:!interface GigabitEthernet3/1 description AP001 switchport trunk encapsulation dot1q ...
Hi,I installed a redudancy sup720 sup-engine on my 6509. But it is not working properly. How can I make the redudancy engine work properly?At first I configured redudancy mode like this:redundancy mode sso main-cpu auto-sync bootvarI place this engi...
Hi,There are three offices which are connected together thru Metro Ethernet. How to trace out which one the opposite router is?Moreover, how to testing the available max bandwidth?Regards,Samuel
Hi all, I am setting up a vpn connection in my office, rather than having this on my dmz, can I have it on another site usign NAT, and permit the relevent ports to it ?
Hi all,I am having the following need:Consider there three routers R1------area0-----R2-----area1-----R3Area1 is nsssa.In R3, I have the following configs:router ospf 100 redistribute static area 1 nssa network 10.1.1.0/24 area 1ip route 150.x.1.0...
If I have 2 physical e1 links on my router, and want 2 1 mb lines on each, do I use 2 channel groups and timeslots 1-16 on each, can anyone help on this ?
