Other Network Architecture Subjects

Hi,On a Catalyst 6509, please let me know the commands to find the RAM on each of the following? 1)Catalyst 6000 supervisor 2 (WS-X6K-SUP2-2GE) 2)Policy Feature Card 2 (WS-F6K-PFC2) 3)Cat6k MSFC 2 daughterboard (WS-F6K-MSFC2) Thanks-Tennis...

HiI need to configure a router for my company. we require 3 fast ethernet port with one serial link .So, please suggest me that if this configuration is rightCisco 2801 2801 w/AC PWR,2FE,4slots(2HWIC),2PVDM,2AIM,IP BASE,64F/128DWIC-1T= 1-Port Serial...

When I try to update the IOS from 12.1(13)AY to 12.1(22)EA4 using CNA I get an error message like this: ERROR: Image requires 0x02000000 bytes of DRAM;only 0x01000000 bytes are presentI what the error message says but how do I solve the problem with ...

Can anyone recommend or provide a link to good technical documentation concerning network performance planning and analysis?Thanks

Hi, I had the following problem last night, I would like to know if anyone have expirienced the same:One module on my catalyts 6509 for any reason took a power down state, at the same time my active supervisor becanme in standby when I did a switch s...

hello can you tel me what is the reel power consumption in function of the number of devices connected for the C2940, the data sheet gives only the max of 15 W

Are they comparable?If I have a switch that uses GBIC and I buy a new switch that uses mini-GBIC would they communicate with no ploblems?

Hi all,As I know 802.1D STP and MST standard, the maximum diameter is 7, may I know that of RSTP?Thanks and Regards,mak

how can we find the number of physical fibre links...pls revert ASAP.thanks

Please see attachment for diagram and questions. Thanks, Khoa

I have a 3750 switch which I want to configure as a static router. It has 24 ports. I want to connect 4 different networks to the switch and setup routing as applicable. The other ports will have servers on the same network hanging off them.

Hi AllI have configured ports 1 -5 on a single 3750G 24TSswitch for dynamic link aggregation using LACP. To these ports are connected a single apple xserve with 5 bonded ethernet interfaces, the bonded int is manually assigned a single ip address. I ...

I have 2 new 3825 model routers with a T3/E3 network module card, in each, on a point to point link. The point to point link is up and running over the serial interface. Both routers are talking via pings/traceroutes from each router. Router A Ser...