Hello,I have 8 2950 Switches which are divided into 13 VLANs.Let say vlan2 has 10 ports. PC1 connects to Port1 until PC10 connects to Port10. I want to apply the Access-list to VLAN2, meaning that I allow only 10 IP addresses of every PCs that connec...
hi i am bit stuck with Vlans.....which switch i have to buy for inter vlan communication...i m v low at budget....so kindly tell me which switch would b best for me....and which router for intervlan communication as i have 2503.....thirdly do i have ...
If I have a site with a cisco 1800 with 2 ethernet connections that is going to be connected to the other site via a 100 meg les circuit, on one of the interfaces, rather than using different ip's can I use ip unnumbered on an ethernet interface ?tha...
Hi I try to get an EtherChannel to a Sun with four GigaSwift Adapters and Sun Trunking 1.3/Solaris 9 up and running. The Sun guys complain that they have freezes in their NetBackup tool. I don't see any log messages about the interfaces going down no...
Hi, Can someone confirm let me know the following :-1) What is the command to add vlans to an existing trunk on a 6500 series .. its using CatOS.Here is the trunk being used.clear trunk 2/5 1-81,83-100,106-111,114-119,122-124,127-139,141-1005set t...
hello, i have just taking over the administration of a lan. i want to configure a switch which is in a rather unreacheable place, but i do not know how. There's no other cisco device connected to use CDP. I pinged the broadcast address (192.168.100.2...
Hello all,In a bit of a hurry here...We have a 3640 router and we're upgrading the IOS. We've cleared the flash: and now have about 16MB free, the problem is the IOS we're trying to load is 17MB.Any ideas? MUST we get the memory expansion? Or is t...
I have a 2611 router that a tech was doing password recovery on. Apparently the config register was set to some other number that 0x42. Now the router has been power cycled and all the n the console our AUX port output is garbage characters. I hav...
I have a pix 515e, which has 3 interfaces. Outside, Inside, DMZ.I need the DMZ interface to act as a tunnel with an outside vender. (basically all communication comes and goes) They are using a secondary external ip address. Which of course I need to...
Hey there-I've a 2950 switch, 1700 router, intervlan routing between them works fine with the 4 networks I've defined. All works well.Now I want to complicate things: one of the networks needs some natting. So, say I had the following:Network #1 (VLA...
