Other Network Architecture Subjects

I've been reading through the documentation but I'm not entirely sure if Cisco ACI supports a totally stubby area. 

I am trying to setup a 3725 with 12.2.(8)T5 to use an ISDN PRI that our telco (Telecom Italia) provisioned with the following channels: - 1-8 are normal channels, capable of incoming and outgoing calls - 25-31 are incoming-only channels16 is signalli...

Attempting to configure VxLAN EVPN on a pair of Catalyst 9500-32C's for a Proof of concept. No joy so far. Been referencing these links: https://community.cisco.com/t5/data-center-blogs/vxlan-evpn-configuration-example-n9k-p2p/ba-p/3663830 https://ww...

hi all i have multiple crypto policies defined on my cisco router(Version 12.4(3c). i wanted to change the sequence of one policy from policy no.6 to  policy no.1 . how to change the sequence of a policy? If we change the sequence, will impact on cur...

Hi everyone, When I'm deploying an image using Cisco prime for stacked switches, should I follow the same process followed for only one switch (select the image/select the device IP) or I do have to consider something in particular (for example in th...

Hello All, I keep getting conflicting information. I need to know if the next generation firewalls are supported by ASDM?Can I continue to manage these devices through ASDM and not FMC or the internal supported management tools if I would like to? We...

Is possible change administrative distance in connected interface (0) ?I like change administrative distance of 0 to 10 or other.

Is there a way to to obtain the total number of switches on our network couting the number of switches within the stack. Meaning if I have 5 stacks with 5 different Ip address but there are 4 switches in each stack the result I'm looking for is 20 ...

Hi Guys,I found some problem in my lab.When I attach switch between two routers.

hi, I can try to create a network traffic. But, whatever I tried I couldn't increase/decrease values that I marked. So , how can create a traffic and visualize or see it ? 

I am in the process of planning for a cold standby disaster recovery site at one of our branch offices and am looking for advice on part of the network configuration. I hope I can explain this in a way that makes sense.We have 9 branch office locatio...

I'm working on my first LIVE IPSEC tunnels.  Attached is my network design.  Site A is our primary site with all the resources.  Site B is currently connected to Site A using a Layer 2 MOE connection.  I'm eliminating the L2 MOE for a Business Cable ...