Other Security Subjects

Hi All,It seems that after 4.1 version of 3002 Hardware client, the group and user password can no longer save in the 3002. And in my network environment, the remote branch office is using 3002 and it will power-off during non-office hour. After powe...

I am trying to configure an address translation on my PIX 515, I have a number of these configured and can't see why this particular one is failing with the message :%PIX-3-305006: regular translation creation failed for tcp src inside:[testmachine] ...

hi guys when dealing with modular policy on an appliance especialy at the stage where we are trying to configure IPS [ ISP (inline/promiscuous..) (fail-open/fail-closed)] is a modular-hardware (IPS CARD)is required or the IOS/PIX can do the job alone...

Hi All;I am using 2851 ISR with SDM. When I enable basic firewall by SDM, network respond dramatically would be slow. Would you please show me how to fix that problem? it is only basic firewall without DMZ and also NAT is enable. thanksAlex

Here is my previous topology which worked good. Mail was coming in good.CableModem -> PIX -> SwitchHad to switch to this because of VOIP box.CableModem -> ATA (phone adapter) -> PIX -> SwitchATA has the public address on the outside and inside = 192....

Hi everyone!I have a CSA MC and i want do do a backup of my events. When i do this i also do a backup of the configuration am i right?What if i want to see (an auditor would ask) some events from 2 years ago backed up 1 year ago. When i would do the ...

I have a client that is looking to replace their existing Symantec Enterprise Firewall/VPN solution with a Cisco solution. Currently, their requirements are as follows: They have a full T-1 frame line coming into a Cisco 2600 router. They have app...

Ok I'm trying to setup Active/Active on 2 Asa5520'sBasically I have 2 core switches connected to each firewall.I want Vlan 50 traffic to route through Firewall 1 and Vlan 100 traffic to route through Firewall 2, for load balancing.How do I setup cont...

please i have the following access list configured and it does not allow internet access.

I want to upgrade the software on our firewall blade from 1.1(2) to 2.3, however, the only documentation I can find that mentions how to do it gives the following example instructions:copy tftp://209.165.200.226/cisco/c6svc-fwm-k9.2-1-1.bin flash:sur...

Hello,I recently upgraded our 515E to 7.2.1 (which wasn't exactly smooth) and I am now getting the following two messages:INFO: Outside address overlap with static NAT configurationINFO: Global address overlaps with NAT exempt configurationThe second...

Hi! I want to configure a tunnel between a 871w (R1) and a 871 (R2).R1 = 80.108.1.1, R2 = 80.109.2.2, these are public IPs.R1 has no private network (yet), but R2 has a 10.0.0.40/29 on the inside. I like to establish a tunnel between R1 and R2 with t...