Other Security Subjects

Dear Expert,We have 8 Public IP and 4 IP has been use as NAT and 4 IP more for PAT. IP for NAT is working well for 1-1 connection, but IP for PAT, we see all the connection using 1st IP. The rest of IP for PAT still no use. I understand, the PAT can ...

Hi, I am upgrading our hardware from a PIX 506E to a 515E(6.3(5). I have a range of external IP addresses I use for services on the internal network. I had them working fine on the 506E. Once I moved to 515E I can not access anything from outside...

Hi,I require to allow access via CISCO PIX Firewall to a Microsoft server using Remote Desktop. What I have done is using web interface to create an access rule to open 3389 on the firewall. No luck, still cannot access. Any other method or suggestio...

Can anyone tell me what this error means?? Doesnt seem like a good thing I know that much. For example if I type dir I get this errorInvalid DOS media or no media in slotThanks,Chris

I'm setting up an 1801 for DSL internet access. The 1801 supports a firewall (which I have no experience with). The docs. talk about CABC allowing any inside user to initiate a session to the outside and temporary ACLs are created to allow outside ...

Hi, I was wondering if a docuement exists (been searching...still searching) that has a set of guidelines for securing a ciscworks installation, or a best practices guide for a secure ciscoworks VMS configuration etc....having some difficulty siftin...

Why I cannot delete an access list PIX 7.0 in running config. I have not assotiated the access list on any interface yet.houPIX525Pri(config)# clear access-list dmz_in6 ERROR: % Incomplete commandhouPIX525Pri(config)#

Can any one please point me to the documnet that describes the various system messages logged by the Cisco IOS Firewall ? Is the messages logged by this same as that of Cisco Pix 6.3/7.0 ?Any pointers is highly appreciated.bye,LT

Hi there,Appreciate it if someone could tell me if SA-VAM2+ is mandatory with 7206VXR NPE-G1?Any big difference in the performance between a 7206VXR NPE-G1 with SA-VAM2+ and a 7206VXR NPE-G1 with IPSec IOS only?Thank you!

Hi all,I have been running into a problem with the virtual contexts and the way that the FWSM detects which context a packet is destined for.I have a situation where i'm in control of an "outer" firewall wth common rules for an organization. I would ...

Hello,When the bug CSCeh32713 will be correct?Thanks

Hi, i´m using a 3550 - 12G switch router as a core switch at my companys office, i have configure a series of vlan and the switch is making intervlan routing by default, the problem is that a i need to setup per vlan security, the classic extended ac...

I was wondering why I am receiving the following error message on my 1711 (spoke)router which is set up to establish a DMVPN tunnel with a 7206 (hub)router: CRYPTO-6-IKMP_MODE_FAILURE: Processing of Quick mode failed with peer at (Hub router address)...

Hi all,again there's a little problem with my CTA.At the moment im testing the new version.I'm using certificates for the machine and the user.When i deploy only User certificate, the CTA is using the machine cert, not the user cert. I checked twice,...