Hi, I'm trying to build a model for L3VPN provisioning with options. Options are: CE bgp routing and CE static routing.
Here's a snippet of my yang model. You'll see later on that variables like "intf-number" and "wan-ip-address" are being used prope...
I need a recommendation for IR extension to work with Cisco Explorer 9865HDC High Definition DVR Receiver. I tried a dual band 38-56KHz IR extension with 3.5mm jack into port #7 (IR Port), but does not work. Cox CAble supplied the DVR but will not he...
Why does the Cisco ASR_903 not support slot 0/5/0, error is below %ASR900INTF-3-UNSUPPORTED: Interface GigabitEthernet0/5/0 is not supported in subslot 5 by the A900-IMA8T[0/5] module
I have ASR 9010 with IOS-XR 6.4.2 i already have more than 50 Bundle as a PPPoE access interface , where each is carrying Max 4000 subscriber in the bast week we increased the user in one bundle and we reached 8600 subscriber , but we faced an issue ...
Hi, I'm facing issues with a CEM interface, the controller E1 is show Up, also CEM Interface, so I only have ingress packets, not outgoing someone can guide me with troubleshoting or any idea what's happen? see log file.192.168.10.1#show cem circuit ...
Hi, I have brand new ASR1001 which we want to use as LNS. Simply the same LNS configuration with 2900 series routers works fine, but no reaction from ASR1001. I guess, any feature (maybe should be enabled), IOS or license should can be cause.License ...
Hi everyone, I have a ASR1006 with two Processors,is ASR1000-RP2 ,i want to know whether we can do SSO with two ASR1000-RP2 in a Chassis,and whether it is same as Catalyst engines SSO ?If there are some logs display by "show logg" command as below:%I...
Hi Friends, we have met a hardware issue of R0 about ASR1006,so we decided to replace it.But,i have some problem about replace the Route Processor 2.Because i did not replace it before this time.Could you please help me to check it? My plan as below:...
HiI need to configure edge and core, with 5 Full BGP Upstream Route IPv4 and IPv6 (IPv4 now approx 700K+ prefix), with VRF to each, and I am also creating another few VRF for selected type of upstream the user wish to terminate to (from the 5 BGP up...
Hi Engineers,i have that question, is it able to route public addresses over private address,let me clarify what i mean,i have checked an edge router in a small ISP and i found that he has a default route with a private address next-hope ,i will show...
Hi I was tried to configured an ASR901 access port for my customer POC in ASR 901 but fail. It does not support for switchport access VLAN commad .I have suscessful setup a port-channel in ASR901 to the Alcatel switch and the LACP is up and in bundle...
