Routers - Small Business

Hello,   We are looking to replace our aged/EOL RV180/RV4000 routers with a more contemporary model like the RV320. Our small library has pretty modest needs so this seems like a good choice. The specific question I have been trying to get an answer ...

Hi,   I use RV042G with two WAN connect to two ISP modem.   I setup load balance WAN. Both ISP modem set to "router mode" with PPPoE.   ISP Modem 1st LAN = 10.1.1.254  (RV042G WAN 1 = 10.1.1.1) ISP Modem 2nd LAN = 10.5.5.254  (RV042G WAN 2 = 10.5.5.1...

I just upgraded my ASA Firmware to 9.1(7)23 and after 24 hours computers were no longer able to access the internet.  When I run the ipconfig /all command the network interface comes back with a public ip that is non working.  If I try to run release...

Hello, I have setup set up access rules for port 5060Tcp from a wan range to a lan single and from the same lan singel to the same WAN range. The outgoing rule works perfectly, but the incoming rule works only for a short moment. I have the impressio...

Hi Team,   We are using Cisco 4431 ISR, one of the interface connected to ISP shows media type as unknown. The media type is force to sfp. The show inventory does not show the transceiver. We are running IOS-XE, Everest 16.6.3   ABC#sh int gi0/0/1Gig...

Hello everyone, I have a small business running and I need to connect three geographical sites on the same network in order to make the various devices accessible by one another. The case at hand essentially requires different printers/scanners/NAS, ...

I have an Cisco RV082 (Firmware ver: 4.2.2.08) working good for me, But recently i have tried to add asterisk server on it.   I tried open 36361 port for SSH connection, but won't work.   I assigned static IP address for my Asterisk server 192.168.2....

I have a Cisco RV320 with FW v1.3.1.12 (2016-04-27, 10:46:12) and two Internet lines from different ISPs. I am using the RV320 in gateway mode and in smart link backup mode with WAN1 having priority. In the past I used the router connected to WAN1 in...

Hi, I just updated the firmware to 1.4.2.19 on my RV320 and the system log stop working. I have unchecked and check the log options and I get it to work, but the next day it stops working. Any ideas?

After receiving a notification about cisco-sa-20140110-sbd and the possible remote access on 32764/tcp I checked the firmware version of my unit and found it to be out of date.I downloaded the newest version RVS4000v2_V2.0.3.2.img and attempted to up...

Hi Everyone, I've a weird issue with the Cisco RV 320 and the USB dongle E3372, becasue the modem is recognized, but I can't go online.My first question is about the IP, becasue I get an internal IP on the USB port instead of a public IP: 3G dongle...

I followed the guide as per instructed in https://supportforums.cisco.com/video/12324451/rv320-rv325-usb-dongle-3g-4g-modem-configuration. I was able to communicate with USB dongle.  Very strangely , I can only ping to google.com, bing.com and bbc.co...

i am customer From Thailand . I so sorry for my Eng skill. I want forward port 211 (and other port) on Cisco RV345.   I  follow Admin Guide on Page 71https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/RV340/Administration/EN/b_RV340_AG.pdf B...

Hi,   We have a RV320 and Telstra 4G Sierra 320U USB dongle. The dongle has a Telstra Data Sim card which when plugged into a pc works fine. Signal strength shows up and shows 3G/4G modem is connected and works normally. No IP is obtained. Using tels...

Using these routers for VoIP phones, the manufacturer says that SIP ALG must be disabled. I cannot find a setting for this.