Routers - Small Business

Hi, I need enable Nat traversal on a router RV110W, I saw that feature on datasheet but I cant find it.ThanksHugo

Recently I bought a CISCO RV220W-E V01 Router. I am trying to setup a SSL VPN Tunnel which is working fine with Windows 7-32.With Windows 7-64 I get a  Virtual Passage Error. From internet reseach I get this is a SSLDRV.sys Driver problem.From intern...

Hi, just buy a RV320 and I have both wan configured to failover.Wan1 has fix ip and Wan2 has dynamic ip. I would like to know if i can configure one router to provide WIFI. I tried to create a VLAN in Cisco and isolate wifi but does not work. The rou...

I just purchased a RV180 last week and connected it to my home network. I set up a couple of QuickVPN accounts and was able to access them without issues. The problem im having is if there is one VPN session active and another client attempts to conn...

Hello Comunity,maybe someone can help with my problem:My Hardware: - cisco RV320 with Firmware 1.1.1.06- Huwaei E392u-12 USB DongleWhen I conect the dongle to the router, the lights are flashing shortly an then happens nothing. The message in the Rou...

Hi everyone, I got some questions about the RV320 router. I currently use a DrayTek Vigor 2920 with a 100MBit/s and one 50MBit/s Internet connection. Because of more and more problems I am looking for a replacement. I found a Live-Webdemo of the webi...

I bought a Cisco RV215W Wireless Router and I set it up to use an IPv4 + IPv6 Dual Stack, WAN and LAN.  The WAN  interface gets an IPv6 address from DHCP.  If I put a computer on the Default VLAN, the computer gets a public IPv6 address and works cor...

Good Evening,  I have a RV180 router which I need to install into a rack in a 3rd party datacentre.  The RV180 is to replace an ageing Draytek.  The purpose of the router is to connect my VM host to the another of my servers which is located within t...

Hello,Here is my situation. I have two real IP addresses on each of my WAN ports. I need to configure:port forwarding (80,443,3389) from Real_IP1 (configured on WAN1) to 192.168.116.10 (same ports)port forwarding (80,443,3389) from Real_IP2 (configur...

I have installed 2 RV220w routers and 5 RV120w routers on a 7 site vpn ( all with the latest 10.5.8 furnware)I am running an Elastix 2.4 asterisk based pbxThe issue I am having is this:With the sip alg disabled and the port forward set for 5060 udp a...

I have 2 rv220w routers and 5 rv120w routers with the lates 10.5.8 firmware on a 7 site vpnI am running an Elastix 2.4 PBX at the first rv220w router locatioThe issue I am having is this:When I have the sip alg disabled and port forwards set on 5060 ...

Hi,how can I configure Access Control Lists to manage the communication between different vlan? As I activate Intervlan Routing, all vlan members can communicate together.Thanks a lot.Thomas

Just purchased a RV180 for my home network last week. Was able to successfully set up a couple of QuickVPN accounts without an issue. Problem is only one VPN account can log on at one time. When another tries to connect and gets to the "verifying net...