Routers - Small Business

Hi,I was wondering how does failover works on Cisco Small Bussines RV016. Specifically, I am interested when one WAN line stop working, and all the computers in the LAN start using another line. Does it means that IP addresses of the computers in the...

We have a couple of older RV082 Routers that we have been very happy with.  However, we have decided to purchase newer models of the same router (v3) so we could run the latest firmware (4.X).I have exported the router config file from the older rout...

Good Morning, I've recently changed my router and purchased a CISCO CRP527W. I had an old NetComm NB6Plus4 thing that needed to change because i changed ISP. I used to be able to access my network via VPN on MAC however I now can't. I've been through...

I have a RV042 with two ADSL services on it, that is a nice simple thing for this unit. The problem that I am having though is that one of the ADSL services also has a /29 attached to it.How do you go about configuring this additional subnet? On a pr...

Hy,I am having problem when try to connect through VPN from MacOS to my RV016 router.The situation is like this. I can connect to the router,the connection is succesfull, but when I try access resources inside the network it disconnects me.The messag...

Hi, to everyone, we bought RV180 to change a Linksys E4200 because we need to do some NAT 1 to 1 for couple of serversRV180 default configurations, no DHCP service, no VPN, no Vlan, static Ip address.Provaider: Comcast (bridge mode) Five external IPs...

Hello, Is it possible to redirect all web traffic to a Symantec web filtering address on a particular listening port. I had a look at the Srp527w Router and can't find where this could be done. Thanks, Sent from Cisco Technical Support iPad App

In the past, I have been able to put two Linksys routers in series no problem but this doesn't seem to work with an RV042.I have a number of customers that need to connect to a private email network via a router based VPN, but since VPN traffic is no...

HelloI have a setup with 2 RV220W at 2 locations.Both with the latest Firmware (1.0.3.5). I configured portforwarding for RDP at one site. Works perfekt. I also configured an IPSec VPN between the 2 sites. Works too.Configuration overview:Site_1:- IP...

I know, this has been posted a gazillion times, but non of the postings I have read really helps me anyway..Well, here goes:I have two RV042 routers with the following settings:RouterALAN IP: 172.16.1.254 / 24WAN IP: 10.1.0.1 / 24   GW: 10.1.0.2Route...

I upgrade firmware from 1.0.3.5 to 1.0.4.17 and from this time I can't connect to any site time from to time. I have simple DHCP WAN connection between my provider and the router, my computer connects to router by wire (only Cisco SG 100D-08 stands b...

Hi,If I blocked off the bonjour service on the router will it effect the iphone 4 from functioning?            Best Regards, Mr. Simon Yee Document Control Budi Feed Sdn. Bhd.(827186-P) Lot 11940, Jalan Perajurit 1, Off Jalan Perajurit, Kampung Tenga...