Routers - Small Business

Hi, I have basic cisco small business pro SRP500 series router (SRP 527W). The router then connected to a firewall and another core switch and then to host (PC and laptops). My question is, when I enter the router webpage to do configuration, why oth...

I have tried to get devices to connect to my RV220W using IPsec for quite some time now. I have all the settings matched on the clients however will not see Tx traffic going from the gateway to the devices (including DNS lookups):This is generally wh...

I'd like to set up access to facebook only between the hours of 12:00 and 1:00 PM and in the evening. Is it possible to use Firewall Schedules to do this? Creating the schedule rule is simple, but I can't figure out how to create an Access Rule that ...

Hello everybody.I got an RVS4000 which on the WAN side has a modem with PPPoE dial-in. On the LAN side, I have a pool of public IPs. The first available IP is configured on the LAN interface (subnet /29), while the next one is configured on a Fortiga...

Hi, when I set up a vlan for the guest network, some connection to the internet stop working. Like yahoo.com or kijiji.ca . When I remove the vlan for the guest everything goes ok. I setup the vlan like said in the manual, I'm on the latest firmware ...

I'm trying to configure the newly install Cisco Small Business router SRP527W. This router is provide by one of Malaysia ISPProblem I found is that, when a user (me) login to the router via web access, than I request my colleague (B), to test the fea...

I'm trying to set up a RV042 to do the following:1) Block all WAN connections, except for:2) Allow all port 80 connections, and forward to 10.4.20.603) Allow all port 443 connections, and forward to 10.4.20.604) Allow port 22 connections from specifi...

Hi all,I have a router SRP521W I wonder if you can setup a self-attendat orivr to this device.Thanks for responding

How can I setup my Internet Access Policy to allow only access to websites I specify instead of deny them access to specific websites. Basically I want to deny access to all websites accept for the ones I designate.              

Hi there,I have an SA520 setup and all my users can login to the SSL VPN tunnel except one user. The laptop is running windows 7 64bit and had IE9 installed. When I try to connect her to use an SSL VPN Tunnel, I get the following error: Cisco-SSLVPN-...

Good day guys, As my title indicates, what Switch,Router and Server will i need for a company of ~ 50 employees.? And another question, If  i have 3 routers,each connects to the internet through a different ISP, is it possible to connect  the 3 Route...

Hi AllAnyone know if there are any plans to incorporate TACACS+ support into the SRP-547W.  The multi level authentication is fine but for a large deployment it does make security management a headache.CheersDean         

my router crashed/reset to factory defaults last night. i tried to restore an old backup but it gave me following error:Restore failure (Unmatched pid)so for several hours i reconfigured it manually and all seemed good.just for the fun of it, i tried...

I'm replacing an older (& failing) RVS4000 v1 with a new V2.  I need to minimize downtime.  Will a config backup from the old v1 restore properly to a new v2 (all have newest firmware)?  There are a lot of tweaks including several VPNs and to do it a...