Routing

Hi All I have a router running zone based firewall, it is also using PAT on the outside interface.   The firewall has been configured, from OUTSIDE to SELF and permits my management IPs, this seems to work OK. However when I attach the NAT to the out...

hello! i need some help... i have a vpn working between 2 sites, one of them(A) has a public fixed IP and the other one (B) has a dynamic IP address. In the dynamic side, there is a server i need to have access from the internet. The ISP in this side...

Good afternoon,   My 2821 is equipped with a 120v 8A power supply meant for PoE / IP phones. However, I've no actual need for PoE. Will disabling PoE on the ports or just not using PoE devices reduce the actual power consumption towards the 3A range ...

All,What's the fastest possible convergence time that you've seen using ibgp? I have a L3 switch that I have 2 routers connected to. The routers are configured with HSRP and the primary automatically fails over if the serial side goes down. The probl...

Given a dialer is associated with a physical interface, say ATM0, is there any functional difference in where I put the "ip inspect..." entry? The same question goes for the ACLs, and the "ip nat outside" configurations.   If there is no functional d...

  Good day, I am encountering an unusual issue with IOSv that I've never seen before. I am currently working on a iBGP next-hop modification lab, and encountering a slight problem I've never seen before when labbing in the past.   Visualize the follo...

Hello Experts, I configured two HUB and 6 spokes, one out of these spoke stuck in IKE state everyday. Can you please advice to troubleshoot the issue. Here is the config attached.   Thanks in advance

Hi All Can anyone give me a basic zone based firewall policy from the router to outside and outside back to thre router. This will be for the BGP peering with the ISP, ssh, https and ping access from outside, and the router itself should be allowed t...

I am looking for suggestions for a small VPN router. Something that my users can just plug into their home Internet to set up a VPN back to the 5500 series ASA at the office. It would be preferable if it were WIFI enabled and small enough to not take...

Good evening all,   I am presently working with an old Cisco 881 router. I have reset it to factory and begun the initial configuration. All interfaces are receiving/sending DHCP. However, I can not seem to get traffic out of the router. I have the d...

We just got a full 1GB internet link.  It's going to be for internet only.  Is it recommended to police it or shape it or can I just let it ride???