Routing

I have multiple 2960x switches, all running Version 15.2(4)E3, RELEASE SOFTWARE (fc2) All have the same config.  I am having an issue with one of the switches.  I have SPAN ports set up as per below: monitor session 1 source interface Gi1/0/25monito...

Why Prefix-list are used instead of access-list in routing protocols ? what make the difference ? Can we use access-list in routing protocols ?

Hi exterts, This is Mandar. I need help to configure point to point connectivity between two sites. Below is the current configuration. site A 3560 core L3 switch available & it is configured in VTP transparent mode. couple of vlan configured with a...

Hi there, I have been banging my head on my keyboard for hours researching this issue and trying to find a solution.I need to forward a range of UDP ports (about 100 of them) for a minecraft server I am setting up and for other services on my network...

Hi Everyone, I have a project to upgrade several sites with new cisco 2911 routers and 2960x switches that already have been purchased.   I have my own scripts (wordpad) for standard configs like aaa, accesslists, local logins, and etc.. is there an ...

Hi, I am very new to Cisco and have inherited a network that has a VPN tunnel to a branch office in Manila from Sydney. The manila branch is noticing that when high utilisation occurs on their 25Mbps link that the tunnel drops and their VOIP (and ot...

Hello,Can anyonme recommend a standard (or well proven) BGP timer for an Internet edge router.  I recently saw a config with the timers set to 7 21 and this seems way to aggressive to me for an Internet BGP peering?Thanks,

Tunnel13 is up, line protocol is up Hardware is Tunnel Description: ### Tunnel 13 ### Internet address is xx.xx.xx.xx/24 MTU 17850 bytes, BW 1000 Kbit/sec, DLY 1000 usec, reliability 255/255, txload 2/255, rxload 1/255 Encapsulation TUNNEL, loopbac...

Hi, we have a 2 3850 stack switches with high utilisation and I will high appreciate if you could help to interpret the output from the commands. #show processes cpu sorted Load for five secs: 0%/0%; one minute: 1%; five minutes: 1%No time source, ...

Hello How can i store the config with the name of the hostname? I would store with cron the config with the hostname which shuld be inserted by command so  show run | redirect tftp://192.168.X.XX/  "Hostname"   .txt Thanks

hi guys need some help on this , when i configure PPPoE should i configure vpdn or a dialer interface? what the difference of both ? thanks chamara

Dear All, My name Mano working as network engineer, currently I do the migrating from GRE Point-to-Point VPN to DMVPN. For GRE Point-to-Point they using Crypto Map on the physical on the interface for encryption method. The connection to HUB and SPO...