Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello, I have a L3 switch that has a static default route pointing to a FW that is connected to an Internet circuit. The same L3 switch is doing EIGRP with routers on our MPLS network. If that static default route goes away EIGRP will inject a defau...

Pete89 by Level 2
  • 3918 Views
  • 3 replies
  • 0 Helpful votes

Hi, here a question about practical difference between shape average and shape peak. In my understanding the difference between average and peak is that "peak" put Bc+Be token in the tocken bucket every Tc while "average" put just Bc token. By defaul...

DMVPN and iWAN Cisco technology.  On Cisco ASR1001-X series router, is it possible to configure two DMVPN domains. 8-10 remote sites will be on staying on existing open-standard non-cisco for IPSec connectivity and the rest of the sites will be conve...

abbasali5 by Level 1
  • 621 Views
  • 0 replies
  • 0 Helpful votes

Hi guys, I have a BGP point to point connection over a 100Mbps link between Branch office and Main office, connection via ISP. I have set up under two cisco routers 2801 with advance security ios a GRE tunnel running ospf protocol so I can share...

Kangalala by Level 1
  • 1595 Views
  • 3 replies
  • 0 Helpful votes

Hi everyone, i have issue on Module switch WS-C6506-E that is Warning status from that sub module VS-SUP2T-10G, with running IOS 15.1(2)SY2, Below is the capture from problematic sub module, Router#show module 6 Mod Ports Card Type Model Serial No.--...

Hi All, I will soon be turning up an iBGP connection over a GRE tunnel as a short term temporary solution. What Id like to know is if I will need to adjust the MSS/MTU over the GRE to prevent any issues with fragmentation for our customers before we ...

Hello.. I am trying to work through a LAN fail-over situation. Currently I have 2 routers running BGP over MPLS. I set up monitoring and tracking using IP SLA to ping the eBGP peer. If pings fail, my active MPLS router will failover to my secondary.W...

Xenogan28 by Level 1
  • 504 Views
  • 2 replies
  • 0 Helpful votes

Dear all, Can anyone help me to resolve my problem.below is sh run of all router in which router R1, R2,R3,R4 communicate with each other its ok but when i trying to ping to router R1 from R4's source interface f0/0 then its not getting pinging but ...

ask for assistance after I enabled the ip address on interface VLAN, ARP list continues to grow, resulting in low memory,  so it can not remote switch from ssh & consol port. the switch back to normal after hard reset, but after 2 day problem again. ...