Routing

Hello All,I have a strange one and can't seem to source the problem.Summary of setup   Internal Network --------Cisco 881-(PPPOE)------------------------(CHAP)---ISP Mikrotik Router  -----------internetBasically it was working then there was a power ...

I am moving from Dell switches to Cisco. When configuring Dell, I lived in the GUI. I will be moving to the Cisco 3750X and am not finding a gui that does anything useful. Am I missing something? The gui just has basic information on the switch, not ...

I have two cisco 4500x vss configured switches as a core switch and SG300 – 28SFP switches five numbers as distribution switches. Both 4500x switches connected to distribution switches by using two fiber cables (Each Distribution has two links to con...

I'm having an issue doing VRF route leak on a 3750. I'm only getting one way redistribution. The following configuration is a snippet of what should be required for it to work ip vrf EDGE rd 65000:10 route-target export 65000:1 route-target import 6...

I have used the cisco software tracker. It has stated that I need to upgrade to 12.2(55)SE11 from 12.2(55)SE10.  I went to the cisco website. I am unable to find this IOS. Is it even available right now?

hai, I am dika, from indonesia, i want to ask to all member in this group. i have trouble to boot from my 1841 cisco router. you have a solution for this ????

we have 1 main site (HQ) and 2 remote office on different location , only the HQ have public ip address and the other remote sites is behind PAT what's the best way to connect these 3 sites together note : i've tried DMVPN but it give the PATed ip ad...

Hi I need pass med from my end of asr1004 to my ebgp neighbour, and I have only found  commandnd 'set metric xxx" on route-map. but, I want pass the med value which routing table has. how can I do it? #sh ip bgpBGP table version is 555, local rout...

hai, I am dika, from indonesia, i want to ask to all member in this group. i have trouble to boot from my 1841 cisco router. you have a solution for this ????

hello all :) i have a cisco2811 but, fatal(?) problem exec!! situation this.  consol cable connected -  power on - flash memory(64mb, new) - putty and i see rommon 1 >  but, does not enter any key. belived? does not enter any key. i want to use rom...