Routing

Hello , I have been unable to schedule recurring reloads on my VOIP routers. I need Restart Every month the router ... I've set :RVOIP1(config)#kron policy-list reloadrouterRVOIP1(config-kron-policy)#cli reloadRVOIP1(config-kron-policy)#exitRVOIP1(co...

Hi,I am going to implement a multihome internet connection to two different ISP. Before implementing in real network, I have prepared the same in GNS3 and testing. Subnet 10.x.5.0/24 should take R1 to outside from LAN and 10.x.6.0/24 should take R2 t...

these icon i find from topology of cisco sba document .but i can'g find these on cisco web site.any one .can tell me where i can find these icom.visio stencils or ppt icon.i appreciate that for you help!

Hi everybody,our cisco 7613 has about  4.5 Gbps  Tx/Rx IP traffic in total, and we run ospf with other cisco cloud for routing I list in the following some our router show.what is your idea about our high cpu usage .Is it in normal range with the lis...

Hi everybody.We have a Cisco ASR9006 with AC power supplies and PEM v1. We need to exchange the AC power supplies for DC ones. My doubt concerns about what exactly we need to buy. As the PEM v1 is no longer available, I suppose that we need the PEM v...

Hello, i need to redirect some external requests to another external ip(through the same interface), how it could be performed?I tried ip nat outside souce static MAP-ADDRESS REAL-ADDRESSbut without success. Thanks in advance   

To All,Good day!Need help to setup redundancy for our core switch.  I have attached our network diagram. Basically we have one core switch & no redundancy in case of failure. Every server is also connected to the switch. Any suggestions on how to set...

HiI have a problem with spoke router, which connected through the DMVPN tunnel to the hub (dmvpn phase 1). Tunnel interface is Up, but encryption breaks from time to time (2-3 times per month). Ipsec connection establishment stops on phase 1 with sta...

Does IOS c2800nm-ipvoicek9-mz.124-24.T5.bin support T1 pri configuration ?? Also, I can't create interface serial on this router ???

I'm attempting to build my first GRE tunnel using 2 celular routers with static IP addresses provided by Verison. Right now I have the 2 routers connected to two different laptops, although I eventually want one to be connected to a PLC. I can succes...

Hi, i would like to connect a Cisco router (2911) directly to the Infinitum DSL network in Mexico. Does someone know which WIC would fit here? Currently I´m trying an EHWIC-VA-DSL-A, but it doesn´t get snyched,whereas the modem delivered by the provi...

My router was configured by another guy and now is locked on this position (Cisco Controller)> can someone tell me how to reset it to factory defaults?

Hi! I am studying for my CCNA and need some help.  I am configured frame relay mulipoint over eigrp psuedo broadcast in a hub and 3 spoke topology. hub can ping accross to all spokes but spoke are unable to ping each other. I disable spilt horizon on...

Can someone please explain me what is the meaning of Bandwidth point in Cisco 7206 router