Routing

Hi All,I'm hoping this is a simple one, but I'm a bit stuck for ideas.I have the scenario of inherting a /21 public network, with the addresses fairly badly assigned in my opinion. Currently the entire /21 is allocated to a single flat network, which...

router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start% Not enough DSP resources available to configure ds0-group 1 on controller T1 0/0/0% The remaining dsp resources are enough for 14 time slots.% For current codec complexity, 2 e...

I need to configure Cisco 2811 serial wic 1T but it doesn't work : Serial0/0/0 is up, line protocol is downSee the architecture in attachmentsI don't know with type of equipment is used on remote sideSee below the configuration of serial on remote s...

HiHow do i configure a router to act as IPV6 RP for a specific multicast group.Registration shld not be allowwed if any device / host try sending registration request for any other group.i have seen some examples where acl is applied with "ip pim rp-...

hello, everybody,This is Lim from south Korea.I am helping to make a document for the internetwork  base design of enterprise company.anyway, I got a question that I mentioned above on title by the document making leader.So I have searched and google...

Cann't login to the router second time accessing the device

One of our vendors uses DNS host names to advertise the IP addresses for certain servers.  the IP addresses for those server seem to be changing quite frequently.Is there any way in any router or ASA release to dynamically adjust ACLs to compensate f...

Hello,I am designing a small datacenter that will host several websites. My goal is to come up with a design that provides high availability inbound route using multiple ISPs for HA. It would be great if someone with some network design background ca...

We have some Cat6500 running 12.2(33)SXH6 and would like to play with IP SLA. However, we found that "IP SLA responder" is missing when we're browsing through "feature navigator". When we input "ip sla monitor responder", it can be shown by typing "s...

Hello,I have this situationCPE_B---(mtu1500)------R1-----(mtu1500)--------- R2--(mtu1500)------R3--(mtu1500)---CPE_A  |                                                                                                                          |  | ----...

Hello All,I am having an network infrastructure. i am having 3 isp connections. WAN 1 , WAN 2 & WAN 3. Currently i am connected  WAN 1 to one network (say 192.168.1.1) & WAN 2 to other network (172.18.1.1). WAN 3 is for Backup.i want a solution forif...