Routing

How does QOS bandwidth work?ExampleIf traffic going from my CE to PE requires 5mg of EF1 and traffic from my PE to CE also requires 5mg of EF1 does this mean I need 10mg of bandwidth or are the two queues separate?RegardsDave

Hi,I'm try to setup a Cisco 867 using two PVC. So what I need is one ATM interface, and two virtual ATM's, ATM0.1 and ATM0.2. And als two Dialers. Can anyone help me with the command order to achief my goal?I have found several config layouts (show r...

Hi,I have just bought an 877W router from a company that has gone in to administration but cannot perform a password recovery. The recovery function has been turned off but having read the proceedure on Cisco's web site thought I would be able to sor...

we are going to use cisco 1841 router. i want to configure leased line inthis router .i will be connecting the local lan in fast ethernet 0/0 with ip 10.10.10.1 subnet 255.0.0.0 and i will be connecting the leased line in the serial port with ip 94.5...

Hi,I have Cisco 3845 with VWIC2-1MFT-T1/E1 card. I would use this card for ISDN backup (data traffic).When I put pri-group timeslots 1-31 on interface controller e1 0/1/0 I got an error:% Not enough DSP resources available to configure pri-group on c...

Hello AllI have a 3750 switch that currently will only display this error:%% Low on memory; try again laterThe only warning/error that is on our logging server previous to this is a traceback error. Their is no history of this on this stack, However ...

I'm not sure if the title makes sense or not but here is my problem.  Cisco 1841 router currently setup with several static routes for web / email servers and such.  Inside IP scheme is 192.168.1.x 255.255.255.0, example of outside IP scheme is 24.1....

I cannot save the config with a copy run start or a wr mem, I cannot believe this issue,each time I turn off the router and re-boot it goes back to default.  yes i did an erase startup config as the intstructions say....I need to save my new config a...

I currently have a Location that has a DS3 terminated into a 7206VXR Router.  We are currently experiencing over 90% Utilization on the DS3 Interface during Peak Periods.  As our Fiber buildout to the Site is over 3-6 Months away we are trying to put...

Dear All,hope all of you doing great,I am going to get a point to point link between 2 offices .I will use this bandwidth for data and voice(IPT)Can I prioritize my voice traffic over data in point to point link.If yes what would be the queing mechan...

Can someone advise the best switch for video optimization?  We currently have a Cisco 4948.  The switch handles both video and standard data.  I just don't feel the video traffic is managed properly.  Can someone also direct me to a link explaning so...

Hi there,I am new to the Cisco command line and IOS so please bear with me. I have a SR520 with ADSL over POTS. I am trying to get the connection with my ISP up and running but have got stuck. I think my "ATM0" looks ok as does my "Dialer0" but my Vi...

Hello all,our company gets a new Ethernet WAN. I am looking for a working dynamic routing design.The company more or less wants me to use ospf.(But i am open to an alternative if there is a good reason)The WAN consists of one or more vlans. The provi...