Routing

The title says it all. I have an ASA5505 connected to a residential ISP provider.  I configured the WAN port as a DHCP client.  The ASA recieved no IP address from the ISP.I then put in a netgear router as my border device and configured the WAN port...

The main question I have here is what kind of cable I need.On one side of the room I have a Cisco 2801 with a T1 DSU/CSU card (WIC?).  The other side of the room I have the white T1 box with "CPE1" and "CPE2" ports.What do I need to connect these two...

Hi guys,I would like to set up an ICMP tunnel from the Internet into my private network, which thus requires a static ICMP NAT entry. You can do straightforward PAT for things like SSH (and any other TCP/UDP traffic) into one's network, but as ICMP d...

Hi,     I have 2 Internet Connection with my client and one cisco router with 2 gis ports.My client has one cheap priced Internet connection and one heavy priced Internet connection.My client has some special demand:-    All Traffic should go cheap p...

I am just learning the 881G router with 3G and am having trouble accessing the AT commands to try and make some modifications to the band that is used.  Here is my config.version 12.4 no service pad service timestamps debug datetime msec service time...

Hi,We are thinking on how we can make our IPSEC tunnels failover automatically. We have a simple design where the IPSEC endpoint is terminated on a PIX/ASA firewall then the other end is our client. We want to have a mechanism that whenever our clien...

Hi,When we telent the device through port 22, then we are getting below message with device name.SSH-1.99-Cisco-1.25.Is this must and Cisco propriorty message in SSH or can we hide this Devie name ( CISCO) in this message.

There are 2 routers which are in pair connected to providers upstream cloud with diverse links. the connectivityon this router is leased ethernet circuits with multiple connections sharing one of the router interfaces, while another interface is unus...

Hi AllI have configured 3G interface on my router, the link is up and running but the link is goes down/idle after 2 minites even when there is traffic over the link.Is there a command to stop this from happening,-------Show interface----------Cellul...

Im beginning to do reseach on a proposal to migrate from an ATM WAN infrastructure to Ethernet.  I searched CCO but did not get any hits that appeared useable.  Looking for any thoughts, ideas, comments, plans, examples, best business practices, etc....