Routing

I have a cisco 2811 device, include two adsl card.Now, I need to configure two dialer interfaces and bundle to two atm sub interfaces. Configuration file like that:interface ATM0/0/0.3 point-to-point ip load-sharing per-packet ip route-cache cef no i...

HiHow to restrict routes injecting via redistribution from OSPF to EIGRP

HIam looking for a design guide with 6509 and ASA 5520thanks

Hi,I have OSPF running on my Cisco 3825 router and I am looking for for a way to simultaneously transmit data using all three available routes instead of transmitting over only one route; i.e. the OSPF route.Would you please give me inputs on a solut...

HelloWhat is the IOS firewall Based for these 2 series routers: 3825-2851Thanks

HelloIs the address between the perimeter router and the outside interface of the ASA are real routable address or just a fake IPs,and pls if u can attache a link describe thatThanks

Hi, we have a E1 in one of our international offices with the above setup. When I perform the "show interface sX\X:X", I notice the "Available Bandwidth 1536 kilobits/sec" statement. The framing is currently set at UNFRAMED. My understanding is th...

Hiam unable to open the following link coz i have a limited CCO.can sone onevdownload it and attached as PDFThanks and appreciatehttp://www.cisco.com/en/US/customer/tech/tk722/tk809/technologies_configuration_example09186a008058f53e.shtml

Hello folks - I am using a Cisco router as a frame relay switch and using 3 other routers in a hub and spoke configuration. R1 is the hub and R2 and R3 are spokes. R4 is the frame relay switch. None of the pings are going across. Below is my configur...

Hi, I have a configuration that I'm desperately hoping that somebody can help me with. I have a very large managed WAN from a telco where BGP is used as the sole routing algorithm. At the moment all sites have 2x connections a 10Mb/s primary link and...

hi..I wonder if there is impact when we deploy the bgp 'multi-path' on live network.It's simple, the configuration is inserted on router bgp config.but we config the bgp multi path, the packet must not loss.the thing what I know is that when I config...

We have two data centers located in two different cities connected to our MPLS WAN. We would like to monitor connectivity between those two data centers constantly, to confirm 100% availability. Can some one recommend some application (open source or...

dear team,in normal case, we used to configure local pref between ibgp nei under single AS means more that one routers, but i configured LP on single router for deciding outgoing trafffic path and ITS WORKING FINE and cisco says that "it is not recom...

I have 2 sites peering with different ISP. I have advertising my own address space (192.168.254.0). both of my sites connceted via layer2 and have ibgp sesssions between my screen routers (AS 100). Site 1 is the primary site. All connections from the...