I have one topology where there is one l2 sw an two l3 switch, all the sw has runnign vlan 10,20,30,50,100 and hsrp is created. I have one host with l2 switch in vlan 10 and default gateway of l2 sw is hsrp gateway of my management vlan which is vla...
Hello,I have a Cisco C921-4P router. I have setup this router to allow my private network (10.10.0.x) to pass through using a NAT to see systems on my company network (10.161.x.x).The issue i am having is that I am unable to ping systems on my compa...
I'm trying to learn Ansible using eve-ng, I only wanna test basic things first. So, I'm trying to ssh a router in eve-ng from the host machine.What I've tried is I tried to make the interface request DHCP address while connected to pnet0 (Management ...
Hello all,we have an issue in a DMVPN Phase 2 topology, one spoke is having a strange problem:The spoke is not an hub but is having a lot of dynamic tunnels with many spokes because there are a lot of services that remote spokes need to access there,...
Hello alli want to create a IP SLA so that i can monitor up / down connectivity using solarwind and use snmp-server event-manager traps on cisco router. the problem is i cannot find MIB relate to event-manager traps. Thanks Agus
I have an ISR 4431 router that is stuck in Controller Mode, running IOS XE 16.12.03 Gibraltar. The command controller-mode disable does not exist in this IOS XE version. Also, having the file ciscortr.cfg in bootflash:/ and it doesn't seem to make a...
Hi i think i may have accidentlly issues the wrong factory reset command on this router and now the licenses dont look right. I issued factory reset all and I think it removed the licenses. Here is what the show license command comes up with:outer#...
HI.As we know for ISR4000 series there are hardware throughput level, if my hardware license now is 100Mbps this mean 100Mbps for all port or for each port?
HiI have a general question, what would be the reasons of ditributing customer routes (xDSL customers for example) into a service provider IGP backbone ? why don't just use BGP to manage routes ? BR
Hey,I'm doing a test lab where im messing around with authentication for different protocols like OSPF. But i cant seem to understand how it works. Authentication is verifying the device you're talking to is actually the device you thin you're talkin...
Hi..We have several interface ip address like in the picture, and why router id of my ospf is 10.103.242.5 and not using my loopback ip address?
Hi all,I have a ASR1001 pppoe server with 2 wan interfaces. Routes manage by ibgp.I would like to use loopback ip for in/out traffic and use it like pref source. Need this because Radius in this way will see only one IPTry to use RMAP but I cant find...
I have following configuation. I dont have any access list or any thing. simple router configurationTunnel connection with my hub (ipsec)crypto isakmp policy 100encr aesauthentication pre-sharegroup 2crypto isakmp key sams@ng address 0.0.0.0crypto ip...
Hi.. We configure ospf on each interface like this interface GigabitEthernet0/0/0ip address 10.103.245.13 255.255.255.252ip ospf network point-to-pointip ospf 100 area 0.0.0.0negotiation autointerface GigabitEthernet0/0/1ip address 10.103.246.13 255...
I am configuring a 2901 ISR with an EHWIC 4G LTE Verizon module for the first time. I've followed the configuration instructions but I'm having trouble with the interface changing state to down every 30 seconds or so. The dialer ...
