Routing

guys if we have config peer group in bgp and suppose we have internal peer group and one external peer group if we have 192.168.1.1 as an external peer group now if we want to applu a route-map to this peer how we would do it i tried neigbor 192.168....

Hi,why we require Virtual-Template on PPP on Frame Relay.

I am totally confused with Offset-List. Please help how to configure it.

Hi all, need enlightenment, i try to configure "distribute-list out" to filter rip routing update. the goal is to access one destination(in this case Lopbck1 on router 1) from different source/segment through different link as well. my configuration ...

I have seen other QosS questions, but have some that apply to me that maybe someone can help with.We have Main branch with 9M (X6 T1) that holds call manager and all the voice servers (IPCC, Unity).The 6 remote branches have T1s with 768k CAR from th...

HiI have 8 E1 line to connect another site.I configure multilink and get bandwidth 17 Mbs. but suddenly when 1 e1 is down then total link is down but show multilink is up. i can not ping connect site. when i pull out the faulty e1 then again connecti...

Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the WIC-1DSU-T1-V2. We are trying to determine - the out of the box - default behavior of this module and what...

hi,where can I download SDM ?I need it for my Cisco 837 ?best regards

Hi,First Happy new year for 2009.I have a Catalyst 3560-48PS-S in 12.2(46)SE IPBASEK9 IOS and I can't apply a "service policy-map input" on my L2 IP Phone FastEthernet ?This syslog is displayed :%QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not su...

I Guys, Is there someone who can help me on how to run a Ghost server in my 3500xl switch. Thanks,Jong

I have a site running EIGRP that has two possible gateways. Currently, one of the gateways is a 10MB PTP that I want to use as the primary.I have a 1.5 MB PTP that I would like to use as a backup (only if the 10mb fails). Here is my question - I pu...

I have an ASA that can't ping ip addresses that end with an even number. For instance I can ping 4.2.2.3 and 4.2.2.1 but can't ping 4.2.2.2 I've tried with different ip addresses but it's always the same result. Any ideas?

Hello,For the most part I understand the purpose of clocking. The majority of our circuits are Sprint MPLS and the clocking is derived from the line.What I'm confused about is how to configure clocking on a pair of routers that are connected to each ...