Routing

Is it better to load balance with a BGP or IGP?Is it better to have BGP advertise the default of the IGP?MAV

Hi all,I'm using OSFF in my network. I have my primary links via fibre and b/up via leased lines. Whenever there a flapping pri link, my remote site registers as down because OSPF keeps on looking for the best path using the fibre link which keeps ...

quick one do we have to enable ipv6 router rip 1 in global mode as well if we want to use rip in ipv6 as i have noticed even if i use them on interface only still it get routes???? its the same with ospf as well can someone please clearify.....thanks

We have 6 remote branches that connect to the main site via MPLS.The Main site has a connection to the Internet.All of these branches use the Main site for their Internet access.We recently had a security audit and they mentioned putting access-lists...

Hi, We are trying to fix a cisco 1760 router which works with only c1700-y-mz.123-16.bin and not with any other images.Please find the error message below:C1700 platform with 65536 Kbytes of main memoryprogram load complete, entry point: 0x80008000, ...

Hi, I have configured three interfaces in one Multilink. The problem is, if any interface link is down, my multilink flaps for 20-30 second & my Citrix connection hang that time. What is the way out. I want any problem in one interface should not fla...

Hi,I have a bandwidth policy setup on an interface to ensure it does not go above 45M.I'm working on a strategy to have this tested out and ensure it works.My qtn is, given i have a couple of routers i can use to generate traffic. How can i send a la...

Hello,Is it possible to use route-maps with ip-prefix-lists as well as bgp network command to advertise networks to bgp-peers? If so which is preferred? Or do they work together?

Hello,I want to build a DMVPN with the possibility of creating dynamic tunnels between spokes. Configuration of the spoke:interface Tunnel0 description *** MULTIPOINT GRE *** ip address 10.0.0.40 255.255.255.0 no ip redirects ip mtu 1400 ip nhrp auth...

This scenario goes well beyond my BGP skills. We have a case where we want only specific ASNs to go through a specific provider while maintaining our AS as the transit AS between the customer AS and the provider AS. Controlling inbound traffic...

I'm trying to assess the best options on implementing site redundancy to the " network default-originate " for all my MPLS sites Internet traffic. I'm trying to validate if I could have 2 CE's within the MPLS network using the default-originate ...

we are looking at creating a backup solution using a dialup configuration.We have a 2851 RTR at our central location and 1841's at the 4 remote ends.I'm pretty sure we can use the AUX port on the 1841 to connect to the external modem.On the central o...

Subnet 10.251.12.64/26 is located at remote location. From central site Core-1 is eigrp neigbhor with 10.90.247.26 (primary path) and secondary internet (VPN tunnel), so from Core-1 we have configured floating static pointing to juniper device. The p...