Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I am converting catos to ios on a 6509..I have 32MB Flash 128Dram..need ip services..is there a ios image that I can use or do I have to upgrade..Greatly appreciate the help !!

ud0508500 by Level 1
  • 314 Views
  • 1 replies
  • 0 Helpful votes

Greetings all. I had a question on a design and would appreciate some thoughts. The customer has a Cisco 2621 with one ISP link via frame relay. Behind this is an existing firewall (not Cisco) that has an address on the ISP1 segment. The customer is ...

hambyg by Level 1
  • 499 Views
  • 3 replies
  • 0 Helpful votes

In my company. We have a 4503 series switch. Tow vlan defined in this switch. Vlan 10.10.16.2 255.255.255.128 and other Vlan 2 10.10.16.130 255.255.255.128 and default gateway is 10.10.16.1. Default gateway is of router. and i have a one link o...

Hi,Please see the PNG file I attached. What you see is a redundant connection between the A and the B site. There is no routing protocol running between the A and the B site. The links between the A and B site are running over a set of switches. The ...

Hi ALL:It sounds crazy but its happening,while configuring the RP for 6500 i have put some static route , but i dont see them in the routing table,this is new switch and not connected to network , any idea why ?***********************interface Vlan62...

vishwancc by Level 3
  • 905 Views
  • 3 replies
  • 0 Helpful votes

Hi, I need help in understanding the completed steps involved in an office move from one location to other.1. Service provider will provide last mile connectivity to the new office.2. LAN cabling will be done by 3rd party vendor3. New cisco equipment...

My company just recently implemented a full DS3 from our office in New Jersey to the headquarters in China. Needless to say the RTT is about 250ms which to my understanding is typical for LFNs. Here is where I am puzzled,If I FTP a 29MB file TO China...

rpinon by Level 1
  • 440 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Dynamips on AMD

I would like to know the AMD hardware configuration needed to run dynamips confortably. I am confused regarding the hardware/Software to go for. Intel or AMD. Windows or Linux???Thanks in advance.AneesH

aneesh.ts by Level 1
  • 1032 Views
  • 9 replies
  • 0 Helpful votes

I am running IOS version 12.3(8)T on a 3745 Router that is a voice gateway. My current image is "c3745-ipvoice-mz.123-8.T.bin". I want to upgrade to a more recent and hopefully stable version of code. How do I know which one will work correctly with...

mparella by Level 1
  • 593 Views
  • 5 replies
  • 0 Helpful votes

Currently all of our remote sites are connected at Layer 3. VLANs from the central location don't propagate to the remote locations. Recently however I have heard that it may be advantageous for us to extend the VLANs at the central location to the...

ancarr by Level 1
  • 3328 Views
  • 6 replies
  • 0 Helpful votes