Routing

I've Cisco2811. Based on show buffers i decided to increase middle buffers.By default was 50 and i increased till 100. After it -Middle buffers, 600 bytes (total 152, permanent 100, peak 152 @ 00:26:04): 102 in free list (10 min, 150 max allowed)...

HiEmergency Does WIC-1SHDSL module support G.hdsl or not ?I know it supports G.shdsl but i want to know if it supports G.HDSL.Thanks.

6500, sup70fwsm/idsm/spa/48port gigbit modulesh process cpu is showing a 99%utilization and found almost all is due to interrupt.what is the common cause of this problem..how to go thru troubleshooting the same..thanks

I recently attempted to upgrade software on a nme-16es-1g module within a 3825 router. Unfortunately, the software that was provided apparently was incorrect. So now the module itself it constantly rebooting. Can someone tell me, or point me to, h...

Does anyone know what the command is for enabling icmp for my ISP so they can monitor the connection?Thank you.

Guys i m trying to install cisco SDM on router.....can someone please tell me how to enable http or https service on cisco router????

Hello fellow CiscolytesIn studying for my BSCI exam (and enhancing my knetwork knowledge in general), do I want to spring up to $300 for a packet analyzer on the eBay?The very specific thing I'm trying to observe is the AS_PATH attribute in action on...

Hi Folks,I have a doubt in DE bit in frame-relay cloud. Normally we used to set this bit on the packets which should be dropped in SP cloud before any other data packets of the client.We use FECN,BECN as well as ECN with WRED to convey the message to...

Hi everybody,I'm searching for a solution to replace two old 3640 router's that have a too high CPU load (average 60 - 70%)for new services. They both have 15 Subinterfaces, and are connected with a 34mbit ATMcircuit on the main interface (each).The ...

OK a few weeke ago I posted a question about QoS vs. PBR. The general feeling was that I should use QoS. So now I am ready to go but I need an example of how to setup QoS, but first let me tell you about the outbound connections. I have a DSL and a ...

Hey guys,what is the configuration syntax so that after the router detects no traffic coming from the peer it kills the tunnel.This is currently what I have, but it doesn't seem to be working.crypto isakmp policy 5 encr 3des authentication pre-share ...

Yet another question. I have a test network environment setup and I'm trying to setup trunking between my two switches. My question is, what encapsulation do my serial interfaces on the routers need to be to allow dot1q trunking? Right now the enc...