Routing

Hi,I forget the enable password of one router. It is working properly. I have the running config file of that router. I remember that some free management tools can decrypt the enable password. Could you give me the link of that management software w...

Can you route traffic from one router to another on the same network? I am trying to route traffic coming over a private T1 out to a Linux router that sends traffic to a load balancer. I have two 1841s handling the T1 which I need to pass the traff...

Hello,Does the cisco 1841 support the IBM SNA technology. I am sure that the 2800 series routers do it but in the case of the 1841 I can't find the information in the technical documents.

Hey all,I have a 877 modem (for reference, running c870-advipservicesk9-mz.124-15.T5.bin) which provides Internet access and routes between two VLANs.I have found recently that when the Internet link flaps repeatedly (unrelated service provider issue...

is the performance of mpls as compared to T lines similar? packet overhead etc? which would have less latency? thank you.

HI.. I have a serial link connecting 2 routers with 7206 on one end and 2811 on the other. The configuration is for frame relay. The 7206 side has g.703 interface and 2811 end has v.35 interface. The link is for 2 mbps but shows only 1.5 as bw on th...

Dear Friends,I have two switches (4500x2) from where a Server is connected.SERVER : is virtually a switch which has 16 ports.Which acts as a switch as well(can read BPDU and trunk information).I want to connect 16 cables ( Fastethernet) to that serve...

Could you help me, please.User terminate pppoe session and must get service-policy input and output from RADIUS server. And router get it, but can't set output policy in Virtual-Access interface.Router 7606-sIn log:%SW_MGR-3-CM_ERROR_FEATURE_CLASS: C...

I have an 1841 with an ADSL HWIC on a BE ADSL2+ connection which was previously working OK with the supplied modem/router so I am sure the line is OK.Although I can sync and get online OK the connection just stops working after a while of not sending...

I have a new private line T1 between two locations. Router 1 has a Serial ip address of 10.10.10.1/29 and Router 2 has a Serial ip address of 10.10.10.2/29. Location A which is the home location has a local LAN of 192.168.0.0/16 and has an upstream...

I will be the first to admit that I have NO experience implementing routers other than the one at home. However, I have been thrown into a situation that I must step up and learn. With that said I am in need of some advise and direction.We have a sma...

Hi, I have configured two sub interface inorder to setup 2 DHCP in a router and HSRP between two routers, HSRP is working for .10 and but not the .71, Config is pasted below for further reference. Out puts of both router's and config is attahched pl...