Routing

Hi,Is it advisable to use the BGP times 5/15 for neighbor peering in production environment..? If not what is the recomended settings..?ex: neighbor 27.150.9.58 timers 5 15Please suggestThank youMS

guys, i have an mpls bet ny-uk,but my voip provider is a different one, i have a public ip given by my voip provider where i need to send traffic to, it is not working, should configure my 2811 with the public ip or my private ip.I am trying to send ...

All,I have multiple customers connecting to a single "aggregate" WAN router at a location for access to remote sites. I need to guarantee each customer a certain percentage of the overall available bandwidth and at the same time prioritize their tra...

Two networks are connected using fiber optics cable with fastethernet media converters at both ends. We are seeing input and CRC errors on the Cisco switches connected to this converter. Whenever we ping across this link we get packet loss between 3-...

Problem-------I have a CSS that is acting as a layer 2 loadbalance it hangs off a cisco switch which is inturned connected to a pix 515e..I am unsucessfull in loadbalancing FTP Requests to our FTP Linux Servers (proftpd)The Symptons are when you teln...

I've read all of the documentation i can find on the 2811 Router. I understand how to backup the Router config and TFTP the file to my laptop. I understand that the CompactFlash card is constantly having an updated operating system (IOS) image writte...

I have a 2811 router running IOS version 12.4.13 and inserted a WIC-1DSU-T1. Running show diag gives the result that the card is "not supported/diabled in this slot".I have tried different slots all with the same results. What am I missing to enable ...

Hi,Can anyone help me understand the BGP scan timer. Any searching yeilds lots of results in relation to MPLS etc. Is there a document that outlines it general prupose?Regards

Hi everyone,I've been trying to deploy a L2/L3 switched based infrastructure that will provide the attached IP multicast fault-tolerant environment.I have sources on one site multicasting a Video stream over dual Eth/IP ports. Each of these ports is ...

Hi,I need some one help me with my problem.I work for a small organization as an network operator.Here in our company they have brought 2 WAN Leased link of2 Mbps each from the same ISP.The ISP according to their policy provides a block of 8 Public i...

Hi!I have cisco 837 Router with ADSL connection with fixed Public IP and one LAN IP 192.168.1.1. The LAN interface is connected to a LAN Switch where an application server 192.168.1.2 is also connected.Is it possible to forward the telnet traffic hi...

i have 2821 router with 2gb int one is used for isp and other for the firewall i am planning to add one more isp from different vendor which will be used only for a set of systems only those will be using the link other will go via exsisting isp how ...

Hi i am getting the following error on my 700 router details System image file is "disk2:c7200-jk9s-mz.124-19.bin"Jun 21 20:55:53: %ENTITY_ALARM-6-INFO: ASSERT CRITICAL PO3/0 Threshold Cross Alarm - B3Jun 21 20:56:03: %ENTITY_ALARM-6-INFO: CLEAR CRIT...

While reading the online Net Academy material I came across this quote:"A nonexistent class can also be used within the policy-map configuration mode if the match condition is specified after the name of the class. The running configuration will refl...